Specifications

Edge-AI Vibration Sensor
6
3. Installation
The sensor supports three installation methods: magnet, glue, M8 stud
Installation Precautions:
1. The sensor should be installed as close to the bearing as possible, or
other location that can effectively reflect the vibration of the equipment.
2. Different sensor installation methods have different effects on the
frequency response curve. See the figure below for details:
(The picture is taken from the Internet, if there is any infringement, please contact us)
Note: Mechanical equipment is usually well insulated. If the mechanical
equipment is poorly insulated, it will affect the signal detected by the
sensor. At this point, the sensor can be insulated from the mechanical
equipment by pasting insulating tape or insulating glue before installing
the sensor.