User's Manual

This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment and it also
complies with Part 15 of FCC RF Rules. This equipment should be installed and operated with minimum distance of
20 in (50cm)between the radiator and yourbody. This transmitter must not be co-located or operated in
conjunction with any other antenna or transmitter
CAUTION:
To comply with the limits of the Class B digital device pursuant to Part 15 of the FCC Rules, this device is
compliant with Class B limits. All peripherals must be shielded and grounded. Operation with non-certified
peripherals or non-shielded cables may results in interference to radio or reception
MODIFICATION
To assure continued compliance, Any changes or modifications not expressly approved by the grantee of this
device could void the users authority to operate the device.
5. Radiation Exposure Statement
This equipment complies with IC radiation exposure limits set forth for an uncontrolled environment. This equipment
should be installed and operated with minimum distance of 50 cm(8 in )between the radiator and your body NOTE To
satisfy FCC exterior labeling requirements, the following text must be placed on the exterior of the end product Contains
Transmitter module FCC ID: ******* Tosatisfy IESD exterior labeling requirements, the following text must be
placed on the exterior of the end product " Contains Transmitter module IC:*******
IC ID
：
This device complies with Industry Canada’s licence-exempt RSSs. Operation is subject to the following two
conditions:
"Operation is subject to the following two conditions: (1) this device may not cause interference, and (2) this device
must accept any interference, including interference that may cause undesired operation of the device."
Le présent appareil est conforme aux CNR d’Industrie Canada applicables aux appareils radio exempts de licence. L’
exploitation est autorisée aux deux conditions suivantes :
1) l’appareil ne doit pas produire de brouillage;
2) l’appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible d’en
compromettre le fonctionnement.
IC ID：
Manufacturer:xxxxx
Address: xxxxx
A voltage stabilizing element or circuit is required on the power supplies to the module, and then the power
supply is sent to the module