User manual

Virtex-II Prototype Platform www.xilinx.com 11
UG015 / PN0401974 (v1.1) January 14, 2003 1-800-255-7778
R
Virtex-II Prototype Platform
Package Contents
• Xilinx Virtex™-II Prototype Platform board
• User guide
• Device vacuum tool
• BNC to SMB cable
• Headers for test points
• CD-ROM
CD-ROM Contents
• User guide in PDF format
• Example design demonstration that flashes the on-board LED. This design includes
the Verilog source code, demo.v, demo.ucf, and a readme.txt file
• Bitstream files (*.bit) for each part type supported by the board (Bitstream
synthesized using FPGA Compiler Version 1999.10)
• Full schematics of the board in both PDF format and ViewDraw schematic format
• PC board layout in Pads PCB format
• Gerber files in *.pho and *.pdf for the PC board (There are many free or shareware
Gerber file viewers available on the Web for viewing and printing these files)
Introduction
Virtex-II Prototype Platforms are prototype and demonstration boards that allow
designers to investigate and experiment with the features of Virtex-II series FPGAs. This
document describes the features and operation of the boards, including how to configure
chains of FPGAs and serial PROMs. Prototype Platforms are intended strictly for
evaluating the functionality of Virtex-II features and are not intended for A/C
characterization or high-speed I/O evaluation.
Features
• Independent power supply jacks for V
CCINT
, V
AUX
, and V
CCO
• Selectable V
CCO
for each SelectIO™ bank
• Configuration port for use with MultiLINX™ or Parallel Cable III cables
• Configuration mode switch