User manual

Virtex-II Prototype Platform www.xilinx.com 21
UG015 / PN0401974 (v1.1) January 14, 2003 1-800-255-7778
Detailed Description
R
5c. Upstream Configuration Interface Connector
The Upstream Configuration Interface connector, as shown in Figure 5, is used to
configure the DUT in select-map or slave-serial mode. This connector can only be sourced
by a the Downstream Configuration Interface connector of another prototype platform.
Figure 5: Upstream Configuration Interface Connector, 44-Pin Female
UPSTREAM_M0
UPSTREAM_CS3
UPSTREAM_CS2
UPSTREAM_CS1
UPSTREAM_CS0
GND
GND
GND
UPSTREAM_HSWAP_EN
UPSTREAM_M2
UPSTREAM_M1
V5
GND
GND
GND
GND
VCC3_EN
VCC3_EN
VCC3_EN
GND
VCC3_EN
V5
UPSTREAM_D6
UPSTREAM_D7
UPSTREAM_DONE
UPSTREAM_CCLK
NC
UPSTREAM_D1
UPSTREAM_D2
UPSTREAM_D0
UPSTREAM_D3
UPSTREAM_D4
UPSTREAM_D5
UPSTREAM_PWRDWN
UPSTREAM_DOUT
UPSTREAM_INIT
UPSTREAM_PROG
UPSTREAM_RDWR
UPSTREAM_TDI
UPSTREAM_TDO
UPSTREAM_TMS
UPSTREAM_TCK
V5
V5
15 13 11 9 7 5 3 11719212325272931333537394143
16 14 12 10 8 6 4 21820222426283032343638404244
UG015_05_051001