Instruction Manual

ManualsBrandsXIMAX ManualsDesigner RadiatorXIMAX 3246BTU Oceanus Designer Radiator

Required tools:

(not included in the delivery!)

1. Determination and scope of use of the

products

- The radiators are designed to be used in a

closed central heating system.

2. Maximimum operating pressure

- Please note the maximum operating pressure

specified in the assembly dimension table. Use

above this level can damage the radiator and

void any warrantee.

3. Scope of delivery of a standard packaging:

- 1 pc. radiator

- 1 pc. Air vent (A)

- 1 pc. Blanking plug (B)

- 4 pcs. Masonry wall plug(C)

- 4 pcs. Screws (D)

- 4 pcs. Washers (E)

- 4 pcs. Wall bracket

4. General assembly instructions

- Check the contents of the packaging for

completeness.

- Make sure that you have the appropriate

connection fitting.

- Before drilling the holes, make sure there are no

hidden water, electric or gas lines behind the wall.

- The distance between the Floor and the bottom of

the radiator should be at least 150 mm so that

efficient heating and ventilation is possible.

- Prepare the necessary tools before and make sure

that there is enough space and a clean, dry

environment for assembly.

- Make sure that you are using the correct type of

wall for mounting. The wall plugs supplied are only

suitable for solid masonry. For other wall types

please obtain the correct wall fixings.

- The specified dimensions are for the main mounting

holes on the brackets. Some brackets also require a

second fixing hole.

Assembly instructions for Designer Radiators

Please read the instructions carefully, before starting assembly.

- The radiator must be installed by a qualified

plumber or another competent specialist.

- Do not dispose of the packaging until you have

secured small parts such as wall brackets and

mounting accessories.

- Note that the dimensions and panel-/pipe layout

of the radiator may differ from the respective

illustrations.

- We recommend wearing suitable protective

clothing such as gloves and reinforced work shoes

for assembly.

Wrench

Tape measure

Flat screwdriver

Phillips screwdriver

Drill bit

Drilling machine

Summary of content (6 pages)

PAGE 1
Assembly instructions for Designer Radiators Please read the instructions carefully, before starting assembly. - The radiator must be installed by a qualified plumber or another competent specialist. - Do not dispose of the packaging until you have secured small parts such as wall brackets and mounting accessories. - Note that the dimensions and panel-/pipe layout of the radiator may differ from the respective illustrations.
PAGE 2
Typical connection options Assembly diagram: ①For radiators where brackets are positioned between the cross tubes: ②For radiators where brackets are positioned on the manifold: Bracket: Bracket:
PAGE 3
③ For radiators that are mounted with a bracket on the fixed bracket on the back: Vertical Horizontal Bracket: ④ For radiators that are mounted on the fixed pins with mounting sleeves: Bracket:
PAGE 4
5. Assembly Instructions: 1. 2. 3. 4. 5. 6. 7. 8. If you use the supplied masonry wall plugs, use the dimensions for the main holes (see assembly dimension table) to drill 4 holes with a depth of approx. 60 mm and a diameter of 8 mm. Place the wall plugs (C) in the drilled holes (only in solid walls). Attach the screw (D) and washer (E) to the bracket for fixing to the wall. Be careful not to overtighten the screw. Some radiators are fitted with a baffle.
PAGE 5
Installation dimension table for bathroom radiators (See packing) Drill hole spacing horizontal "X" Drill hole spacing vertical "Y" Hub spacing (NA) Connection type Max.
PAGE 6
Mounting dimensions table for room heaters Drill hole spacing horizontal "X" Drill hole spacing vertical "Y" Hub spacing (NA) FOR / NO / BRI B - 208 mm H - 100 mm H - 50 mm default Max.