User's Manual

Instruc on Manual
READ ALL INSTRUCTIONS CAREFULLY BEFORE USE AND KEEP THIS
MANUAL
In the Box
UV box with wireless charger (x1)
Power Cable (x1)
User Manual (x1)
Safety Precau ons
This product is NOT a toy, keep aw
ay from children and pets.
Only use the device according to the instrucons in this manual.
Never use the device for anything other than its intended purpose.
This device is
NOT a substute for proper medical equipment or
aeno
n.
ONLY use the sup
plied power cable.
Do not open this product or aempt to repair the unit yourself if it
is not working properly. Doing so risks re, shock or injury.
The device contains a safety feature that powers it o automacally
when the cover is opened. Do NOT disable this safety feature.
Never allow UV-C light to shine in eyes or on skin.
W
hen not
in use, the device should be stored in a dry, cool locaon,
away from sources of
water or heat.
Do not expose device or power cable to extreme temperatures
(heat or cold), open flames, humid or wet condions.
Do not submerge in water. Do not use in a locaon where the
device or power cable could fall into liquid.
Unplug the charging cable when not in use. Do not pull the charging
cable to disconnect, or use the cable as a handle.
Do no use if device or power cable is damaged. If device or power
cable is damaged, it MUST be serviced or replaced by the
manufacture or its service agent before using agai
n.
Do NOT place any metal object onto the charging pad.
Magnec strip cards, including credit cards, phone cards,
idenficaon cards and boarding passes may be damaged by the
magnec field if placed on or near this device.
Do not place this device on or near a microwave or similar kitchen
appliance.
Product
Connec n
g to Power
Place the UVC chamber on a at, solid, stable surface.
Plug the small connector of the included power cable into the
power port on the back of the UVC chamber.
Plug t
he large connector into a USB power source, such as the USB
port on a computer or into a
compable 5V/2A USB adapter (not
included) and
plug into a wall socket.
Using the UV Sani zer
Set up the sanizer & connect to power. Open the cover of the sanizer
from the front, and place the device you would like to clean inside of the
sanizer. Close the lid.
The UV sanizer has two sanizaon modes: Fast Sani ze mode and
Deep Sani ze mode.
Press t
he [Power] buon once to start Fast Sani ze.
Double press the [Power] buon to start Deep Sani ze.
When Fast Sani ze mode is acvated, the LED indicator on top will
turn BLUE, and the sanizer will sterilize for the next 90 seconds.
When it is nished, the LED indicator will flash BLUE 3 mes then
will turn o.
When Deep Sani ze mode is acvated, the LED indicator on top
will turn GREEN, and the sanizer will sterilize for the next 5
minutes. When it is nished, the LED indicator will flash GREEN for
3 mes then will turn o.
The charging LED on
the power case will flash RED when charging
and stay solid RED when fully charged.
Once the UV sanizer completely nishes sanizing, open the lid, flip
your device over, and repeat the sanizaon process again for the
other side of your device.
Cau on: This device is designed to limit human & animal exposure to
UV-C light, as it is harmful to skin and eyes. This device is equipped
with a safety feature that automacally shuts the UV-C light o when
the lid is opened.
Using Wireless Charging
Connect t
o power. The wireless charging LED indicator will flash
RED and
BLUE 3 mes, t
hen turn RED to indicate the wireless
charging is in standby mode.
Place your Qi enabled device on top of the cover. The wireless
charging LED indicator will turn BLUE to indicate that your device is
charging properly.
If your device does not begin to charge, try reposioning your
device on the charging pad. You may need to remove your
smartphone case to charge properly.
When your device is fully charged, the wireless charging LED
indicato
r will turn OFF. Dis
connect and
unplug the charging pad.
Note on Safety Features:
The device will automacally power OFF whe
n it
is
overheated, or
when a metal object such as a coin is placed on the charging pad
.
The wire
less charging LED indicator will flash BLUE to warn o
f
automa
c
shuto.
Tech Specifica ons
Input 5V 1.5A
Wireless ch
arging output 5W
FCC Informaon
This device complies with Part 15 of the FCC Rules.
Cauon: Any changes or modicaons not expressly approved could
void the user’s authority to
operate the equipment.
Note: this equipment has been tested and found to comply with the
limits for a Class B digital device, pursuant to part 15 and part 18 of
the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation.
This equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference
will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which
can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the
following measures:
Reorient or relocate the receiving antenna.
Increase the separaon between the equipment and receiver.
Connect the equipment into an outlet on a circuit dierent from that
to which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
This device complies with part 15 and part 18 of the FCC Rules.
Operation is Subject To the following two conditions:
(1)
This device may not cause harmful interference, and (2) this
device must accept any interference received, including interference
that may cause undesired operation. Changes or modifications not
explicitly approved by the party responsible for compliance could
void the user's authority to operate this equipment.
Made in China
1x press:Fast Sanize (90 seconds)
2x press:De
ep Sanize (5 minutes)
SIZE:520*180MM
Double-sided printing instruction
Made of 128G copper paper
TOP
BOTTOM
UV box with wireless charger
XO-9969
XO-9969
This device complies with Part 18 of the FCC Rules. This equipment
generates uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause
harmful interference to radio communications. If this equipment
does cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one or more
of the following measures:
●Increase the separation between the equipment and any other
radio device.
●Connect the equipment into an outlet on a circuit different from
that to which the receiver is connected.
The equipment complies with FCC radiation exposure limits set
forth for an uncontrolled environment. During the operation of
device a distance of 15 cm surrounding the device and 20 cm above
the top surface of the device must be respected.

Summary of content (1 pages)