User's Manual

13
30
n Receiving a Call
When a call is received, t
If the caller can be identified, the caller's
phone number is displayed. If the caller
cannot be identified, only the
displays.
1. To answer the call, press the key. If
you have activated the Auto Answer
function, when the handset is on the
base,simplyliftituptoanswer.
he
information will appear on the LCD.
information If you have a voice
message, the icon and " "
will be shown on the LCD.
2. To end the call, either press the key
or replace the handset on the base.
New Call
New Call
MSG WTG ON
Result: After you hang up, the LCD displays the
call duration.
Notes:
You can select the ringer volume by using
the or key when the phone rings with
an incoming call.
If you want to deactivate the icon, press
the key in standby mode, then press and
hold the key. After that, press the key
to return to standby mode. (The handset
must be registered to the base.)
If the polyphonic ring tone is set, the ring
tone may continue for 4 seconds after the
caller's hang-up or after the parallel phone
had answered the call.
n BS Settings
Terminate HS
This function allows you to delete a handset
registration from the base.
BS Settings
Select
Select
Terminate HS
PIN?
OK
Select
soft key
3. Press the soft key to choose the
menu. The display shows
" " to prompt you to enter the PIN Code
(The default PIN Code is "0000"). Then press
the soft key.
4. Use to select a handset, press
the soft key to confirm. Then the
selected handset will behave according to the
unregistered condition.
, a warning tone will be
heard.
1. Press the soft key.
2. Press or key to choose ,
then press the .
or key
Menu
If you select the
current handset you are using or if you select
a non-existent handset
Flash Time
You can select to change the Flash time by the
following steps:
1. Press the soft key.
2. Press or key to choose ,
then press the .
3. Use or key to choose menu.
Press the soft key.
4. The display shows the current setting. Use the
or key to select / ,
press the soft key.
Menu
Flash Time
Select
Flash-1 Flash-2
Save
BS Settings
Select soft key