User's Manual

Operating Your HeadsetOperating Your Headset
Charging Your Headset
First Time Use
Recharging
Before you can use your headset, you need to charge its self-contained Li-ion
battery for 24 hours.
When you hear 5 rapid beeps through the headset speaker, repeated at 20
second intervals, the headset battery needs to be charged. You could only use
the headset for about 10 minutes after the beeps start.
After the battery is fully charged, the indicator LED will turn off. It takes 1-1.5
hours to fully charge the battery. Do not charge for more than 24 hours.
Over extended periods of time, batteries gradually wear down and require
longer charging times. This is normal. The more you talk on the phone with the
headset, the less standby time your battery has.
Device Status
Action
Function
Toggle
between
2 active calls
Transfer call
from headset
to phone
ON (in call
with 2 call
1 call
on hold)
nd
st
Phone Headset Hands Free Profile
Long-Press MFB to place the 2 call
on hold and answering the 1 call.
nd
st
Operating Your HeadsetOperating Your Headset
ON
(in call)
ON
(in call)
ON
(in call)
Extended-Long-Press MFB, headset is
OFF (4 tones to be heard from high to low)
and the call is transferred to the phone.
Transfer call
from phone
to headset
ON
(in call)
ON
(idl )e
OFF
(paired
before)
ON
(not
connected)
Long-Press MFB to on the headset.
Connection is established and the call is
transferred to the headset.
Short press MFB, headset will try to
reconnect to the last connected phone.
Note:
1. If the link abnormally disconnects (for example, out of range) the headset tries to
re-establish the link.
2. The headset will automatically try to connect to the last connected phone upon power up
for the first 90 seconds.
18
7
User initiated
reconnection