User's Manual

10
Chapter 2: Bluetooth Settings
Pairing with an iPhone
To use an iPhone with your BT handset, you must first pair
and connect the iPhone with the BT handset.
Place the BT handset and the iPhone close to each
other, within about a meter.
Turn on the Bluetooth feature of your iPhone. Click
, , and , then the
iPhone searches for available devices.
Make sure the BT handset is off, and then press and
hold MFB for about 6 seconds until the red and blue
indicator flash alternately.
When the iPhone finds , click to
connect it with the base. The iPhone prompts you to
enter the PIN (the default PIN is 0000). Enter it, then
click to confirm. When the iPhone is successfully
connected, displays, and the handset blue
indicator flashes, 1 second on and then 3 seconds off.
Settings General Bluetooth OFF
i-350 Not Paired
Pair
Connected
1
2
3
4
11
Connecting an iPhone
Although two iPhones can be paired with the BT handset,
only one iPhone can be connected to the base and be
engaged in a call at one time.
The BT handset will connect to the last paired iPhone
automatically when the handset is switched off then on,
and within 10 meters range. Ensure the Bluetooth feature
is enabled on the iPhone.
If you switch off the Bluetooth feature on the iPhone and
then switch it on, you should connect it again. Click
to the right side of on the iPhone screen.
After the connection is successful, appears.
Not
Connected i-350
Connected
Notes:
Make sure the handset and the iPhone are no more
than a meter apart, so they are within operable range.
If the handset is not successfully paired within 2
minutes, after a long beep, it will automatically leave
pairing mode. If you still want to pair, please repeat the
steps of pairing again.
Note:
To pair a new iPhone, remember to switch off the
Bluetooth feature on the paired iPhone and turn off the
BT handset.