speeCup Product Information Guide
IMPORTANT ADJUSTING VOLUME To get the full capability of your new speeCup, please read this manual. It's more than just a Bluetooth Speaker! To adjust speeCup’s volume, rotate the smartControl clockwise to increase the volume or counter-clockwise to decrease it.
AUDIO OUT CHARGING speeCup can also be connected to other audio devices like your car audio system, home audio system or sound bar via 3.5mm Audio out jack. speeCup has a built-in Li-ion battery (3.7V, 1.6A), so it can be used without connecting to a power supply. To charge the battery, follow these steps: After speeCup is connected to another audio device, the volume of the conversation is transmitted via speeCup while the music and ringer sounds via the audio device.
SMARTCONTROL INTERFACE Top view Smartphone Voice Command access Bottom view smartControl perimeter interface Music track UP/Down buttons LED status indicator Front view GESTURE Microphone Power ON/OFF switch Rear view 1. When a call is received, wave left or right in the direction of the gray arrows to answer it. For details, see the picture below. 2. To end a call, wave left or right again. 3. While playing music, wave left or right to select the desired track.
USING VOICE COMMAND FUNCTIONS OPERATION Voice commands with Siri or S Voice OFF Turning speeCup On or Off Simple voice commands of numbers or contact names can be given to speeCup by pressing the once briefly in the center of speeCup and wait to hear the sound indicating voice command is ready to access. Voice commands with Siri or S Voice Enabled To access voice commands press the once briefly and wait to hear the sound indicating voice command is ready to access.
Clear speeCup from iPhone Touch the small blue arrow as below, then you will see Forget this Device, touch this option and confirm by the red prompt. Clear all the devices from speeCup Turn the speeCup to the ON position, then press and hold the smartControl for several seconds until you hear a confirmation beep.
Compliance statement 1. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference. (2) This device must accept any interference received, including interference that may cause undesired operation. 2. Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.
