User's Guide

9
4. Quick Start Guide
4.1 Device Installation
The XT1010 (Sensor unit) pairs with the XT-4860G5 (Base unit) and provides inclinometer data
based on the on-board 3-axis digital accelerometer output which in turn is transmitted to end
user Server over the cellular network. The proper installation of the unit is critical to acquiring
accurate inclinometer data. An application note entitled “Installing and Pairing the XT-4860 and
XT-1010 for Wireless Inclinometer Functionality” contains detailed instructions for installing and
pairing the two devices. This quick start guide will give you basic steps for installation and
pairing of the two devices. Refer to the application note for any additional detail and instructions.
When installing the device, make sure the Base unit (XT-4860G5) faces the Sensor unit (XT-1010)
Each Unit has a label near the 8-pin Connector to show the direction of device installation. The
Base and the Sensor must be on the same plane and facing each other for optimal performance.
The picture below illustrates the ideal orientation of the two devices
As an example, below depicts possible mounting positions of the two Units for a man-lift
application.
FACE BASE UNIT
FACE SENSOR