User's Manual

3.7 XT3630 Commands Description

When you connect successfully you will be able to send console commands to the device. The console

commands are case sensitive and must be entered with the return key. The list of applicable commands shown

in the table below:

USB Console Commands

sSHDN5

Sets the device into ship mode (low power sleep mode)

Prints the version of the FW

Xpd

Prints various ADC values (helpful for checking battery voltage)

deM

Firmware Update Command using Xmodem transfer

+XT:4001,<WFE>,<WSI>,<WSD>

Enables/Disables Wi-Fi Scanning and sets scan interval and

duration.

+XT:4002,<GE>,<GA>

Enables/Disables GPS and sets minimum fix accuracy

+XT:4003,<BE>,<BM>,<BAM>,<BAI>,<BAN>

Enables/Disables BLE and sets status, data mask, interval, and

name

+XT:5401,<ST>

Configures Sleep Timer

+XT:3017,<WT1>,<WT2>,<WNM>,<MWM>

Configures wait times and sleep mask

Rpi

Displays Wi-Fi APs and RSSI

Sxx

Reset the device. This will allow the devices to be secured after

logging into the device via serial cable.

Please remember to place the device into ship mode (‘sSHDN5’) if the device is going to be charging or non-

operational for a period of time. This will keep the battery from draining during expected non-operational

periods of times. The 4001, 4002, 4003, 5401, and 3017 commands syntax are the explained in Appendix A.

3.8 XT3630 Firmware Update

Within ZOC Terminal Issue the following command

deM

When prompted by the ZOC console with:

Preparing firmware download (.evf)

Erasing FLASH memory

Waiting for Xmodem Start ("dE" to abort)

Now navigate to the ‘Transfer’ drop down menu and select ‘Upload’. Browse to the directory where the .evf file

is located, select the file and click Ok.

The firmware update process will begin and the console will report when the update is complete.

Once completed, type ‘mV’ into the ZOC console to view the updated firmware version.