User's Manual

13
Sales Engineering
[e-mail]
Parameter File
The parameter file is the setting for all of the XT6360 hardware peripherals, network behavior, and
inputs to core functionality of the XT6360. The following table contains all the parameters that can be
configured in a XT6360:
Acceleration event
thresholds
Accelerometer report
correction
APNs (GSM only)
Crash event params
Debounce settings
Destination
ECU_Thresholds
Flag save mask
Garmin Blacklist
Geofence
Input default polarity
Ignition sense
MIP/SIP Control (TBD)
Motion sensitivity
NMEA stream output
Odom Ign Off accum
Packet Creation Append
Packet Creation Recipe
Packet Retry
Serial port settings
Timer duration
OBD RPM and Speed
OBD Accel and Decel
Variable save mask
See Appendix C for Parameter settings.
Creating a Parameter File:
1. The parameter settings are written and saved as a .txt file.
2. Use :wycfg in front of the parameter your are configuring.
3. To load the parameter file you can use XDMI or load the file over Serial Port 2.
a. Load via Serial port use the following commands
i. :uyscr x 2 load the file
ii. :vycfg Save the parameter file
Below is an example of a parameter file.
:wycfg pdo 0 1
:wycfg dst[0] "71.24.53.116" 65534
:wycfg dst[9] "none" 65535
:wycfg pcr[0] "00080104030607080b17"
:wycfg pcr[1] "01050103070809"
:wycfg pcr[2] "02140104535455565758595a5b5c5d5e5f6061622c2e"
:wycfg pcr[3] "030701040305060708"
:wycfg pcr[4] "040701040305060708"
:wycfg pcr[5] "050701040305060708"
:wycfg pcr[6] "06080104030607080b17"
:wycfg pcr[7] "07080104030607080b17
:wycfg pcr[8] "08040104060c"
:wycfg tmr[0] 90 1
:wycfg tmr[1] 90 1
:wycfg aet[0] 0 1000 1000 205