User's Manual

Baracoda RoadRunners User Guide

List of 2-digit identifier codes can be found in the programming guide. You can configure barcode

identifier through programming guide (more information in the programming guide).

The barcode identifier is disabled in default settings

8.5 Beeps and LEDs

You can enable/disable Beeps / LED Lightening using both BaracodaManager and programming guide.

You can also invert the position of the two leds.

9 Other functions

9.1 Power management

You can configure your scanner to work at 20 dBm (default setting) or 10 dBm through BaracodaManager

or through configuration barcodes.

Due to local laws, you may not use 20 dBm in some countries.

Please refer to your local laws before using your scanner.

9.2 Sniff period

The higher the Sniff period, the higher is the latency and the smaller is the power consumption.

Default value is 150ms.

9.3 Low battery

An alternation of red and green blinking on the two LEDs indicates that the battery level is low. Recharge

batteries immediately. If you continue using the scanner, RoadRunners will continue working till a triple

beep occurs: at that moment the reader will shut down and you will be forced to charge the scanner.

9.4 Security

The Bluetooth connection is secured with a PIN code authentication.

You can configure security (enable/disable/change PIN code) through BaracodaManager and through

configuration barcodes.

The Security is enable in default settings: default PIN code is 0000.

10 Safety / Regulatory.

Emissions: FCC Class B

EN60950 & EN60825-1

VCC1-B

Electronical: UL, TUV

FCC Statement:

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:

(1) this device may not cause harmful interference, and (2) this device must accept any interference

received, including interference that may cause undesired operation.

For questions regarding your product or this FCC declaration, contact:

Baracoda, Inc.

45 Main street - Suite 616 - Brooklyn, NY 11201