Installation Manual

EXI HALO Installation Manual Rev 2.0



EXI Wireless Systems Inc. Page 13 June, 1999

3.1.4. SET CONTROLLER SWITCHES FOR NORMAL OPERATION

Flip open the Controller lid to set the switches inside for the desired operation.

Figure 8 – Controller Switch Identification

MODE SWITCH SETTING

Change switches to desired operating mode as outlined below.

Mode Controller Function Response

0 Test Mode

1 Patient Monitoring with DKX Alarm ends on its own – fixed maximum bypass time

2 Patient Monitoring with DKX Continuous alarm - fixed maximum bypass time

3 Patient Monitoring Alarm ends on its own – fixed maximum bypass time

4 Patient Monitoring Continuous alarm - fixed maximum bypass time

5 Article Surveillance – Protection Alarm ends on its own – bypass extended by new tag

6 Article Surveillance – Protection Continuous alarm - bypass extended by new tag

7, 8, 9 Reserved for Article Surveillance -

Monitoring

A Authorized Entry 4 second release

B Authorized Entry 8 second release

C Authorized Entry Keep released while tag in field

D,E,F No Function

Modes 1 and 2 will only allow Bypass when the field is clear of Tags and the user enters a se-

quence of key presses on the DKX as described in the HALO Operation Manual. Keypads are for

Article Surveillance and Patient Monitoring Modes 3 and 4. The Pinpad can be used with any of

the Modes.

OPTION SWITCH SETTING

“Mode”

“Option”

Switch

“Range Adjust”

J2: Relay function

Relay 1 = TIF

Relay 2 = TIC

Both TIF