Operations Manual

EXI HALO Installation & Operation Manual 981-000003-000
EXI Wireless Systems 43 March 2000
Revision 2.0
Figure 38 - Dealer Toolbar Figure 39 - Floor Plan Entry
In order to add a floor plan, one has to be created in the BMP (Bitmap) format. The maximum allowable
size for a floor plan is 1010 pixels in the horizontal plane, and 660 pixels in the vertical plane. This image
should be stored along with other floor plan images in the directory named “C:\Program
Files\eXI\Halo\floor plans\” which is the default directory for floor plans set up at the factory.
Once a bitmap has been stored in the above location, click on the “Add” button in the Dealer Toolbar. A
panel appears as shown below. Type in the name of the floor, and then click on the “Browse“ button to
locate the floor plan in the default directory described above. The floor plan will be placed under a new
button that has the name of the floor as you had entered.
8.2.3. Adding System Devices
New System Devices such as Controllers, Receivers and Elevator Controllers can be added to the system if
necessary. Remember that all devices in the original installation plan are already added into the application
at the factory, and therefore there should be very little need to add more in the field. This may only become
necessary because of substituting a RIM device, or adding more nodes.
In order to add devices, click on the “Dealer Only” tab and click on “Add”. Fill in the appropriate
information in the “Add Node to System” panel and click on “OK”. Note that the “Node Number” is the
serial number of the RIM associated with the device added.
Figure 40 - Adding a Node to the System
If you try and leave the “Dealer Only” screen after changes are made, a warning pane appears.