User's Manual

Installation Guide: Access Control Reader Installation Guide: Access Control Reader
Document Control
Document Number: 981-000293-000
Date Rev # Comments
7 Feb. 06 R1.1 Released for testing.
3 Mar. 06 R1.2 Graphics added. Installation instructions expanded.
9 Mar. 06 R1.3 Antenna tuning instructions added.
Page 19 PN: 981-000293-000 R1.3
The Antenna cable plugs into the connector shown in Figure 2.
Figure 2: Controller Module Antenna Connection
Antenna Description
The Antenna can be mounted indoors either on a surface or inside a wall.
A 10 ft. (3 m) power/signal cable is permanently attached to the Antenna and mates
with the Controller Module.
6 Relay N.O. Relay Normally
Open
• 10 A 250 VAC resistive
• Protective diodes are required for an
inductive load.
7 Relay COM Relay Common
8 Relay N.C. Relay Normally
Closed
9 Wiegand 0 Wiegand Data 0 Standard 26-bit format (24 data bits and
2 parity bits) Wiegand output.
10 Wiegand 1 Wiegand Data 1
11 Input Dry Contacts Pins 11 and 12 form an input for a door
contact or other device.
12 GND Dry Contacts
Table 1: (Continued) ACR 12 Pin Wiring Connector
Pin # Label Type Description
Antenna Connector
Page 4 PN: 981-000293-000 R1.3