User Manual

www.xmarto.com
13
maximum coverage.
 Do not place near high voltage wires or other sources of electrical interference. Electrical
interference will degrade the quality of the signal.
 Place camera out of reach to avoid vandalism.
 Avoid direct exposure to weather. Do not place the camera where rain or snow will hit the lens
directly nor should the camera be placed so that the sun or bright light shines directly into the lens.
Your camera is weatherproof, but it will not work when submerged in water. Ensure that all power
and video connections are not directly exposed to water and are protected from the elements.
 The mounting surface must hold at least four times the camera’s total weight.
1. Locate a camera and choose a location where you would like to mount the camera.
2. Indicate screw positions by marking three holes on the surface where you plan to mount the camera,
using the holes in the camera base as a guide.
3. Using a drill bit slightly smaller than the included screw anchors, drill into the mounting surface
using the guide marks you placed in the previous step.
4. Insert the screw anchors.
5. Line up the camera base holes with the screw anchors. Holding the base in place, insert screws and
tighten until secure.
6. Once the base is screwed in place, make sure that the camera is securely mounted by placing gentle
pressure on the mount.
7. Adjust the camera housing to point in the direction of the area you would like to monitor.