XOA30 XOA36 READ AND SAVE THE INSTRUCTIONS FOR RESIDENTIAL COOKING ONLY Register your product online at: www.xoventilation.
Dear Customer, If you follow the recommendations contained in this Instruction Manual, our appliance will give you constant high performance and will remain efficient for many years to come.
WARNING TO RUDUCE THE RICK OF FIRE, ELECTRIC SHOCK OR INJURE TO PERSONS, PLEASE OBSERVE THE FOLLOWINGS: length) 1. Installation work and electric wiring (including switch location) must be done by the qualified person(s) in accordance with local applicable codes and standards, including firerated construction. 2. This hood may have sharp edges. Be careful to avoid cuts and abrasions during installation and cleaning. 3.
WARNING - TO REDUCE THE RISK OF A RANGE TOP GREASE FIRE: 1. Never leave surface units unattended at high settings. Boilovers cause smoking and greasy spillovers that may ignite. Heat oils slowly on low or medium best capture of cooking impurities. 6. This hood is not intended to be used as a shelf. 7. Please read specification for further information and requirements. settings. 2. Always turn hood ON when cooking at high heat or when cooking flaming foods (i.e.
2.Install the large shutoff plate on the back of the hood. Using 5 screws. HOUSE WIRING 3.Install the rubber gasket(Included)on the top of the hood. As shown below. 26"-32" ** Duct and roof cap/wall cap are not supplied. Warning: to avoid the risk of fire, use only the metal ductwork. HOOD PREPARATION 1.Remove the bottom panel of the hood by removing its (7) mounting screws and set aside. 6’’ ROUND DUCT INSTALLATION 4.Mount 6’’ round duct on the top of the hood, using 10 screws 5.Seal with duct tape.
2.Mount the shutoff plate on the top of the hood, using 10 screws(Included) 3 1/4’ ’×10’ ’ DUCT INSTALLATION 4.Mount 3 1/4″×10″duct on the top of the hood, using 5 screws(Included). 3.Seal with duct tape. 5.Seal with duct tape. 4.Install the adapter in the back of the hood, using 6 screws. HOOD PREPARATION-HORIZONTAL DISCHAREG INSTALLATION 3 1/4’ ’×10’ ’ DUCT INSTALLATION 1.Install the gasket (Included) on the top of the hood, as shown below. HOOD INSTALLATION 1.
CAUTION: 1.THE SURFACE, THE COVER OF THE HALOGEN BULBS MAY BE HOT. TAKE CARE WHEN TAKING THE REPLACEMENT. 2.BULBS MAY BE HOT. TAKE CARE WHEN TAKING THE REPLACEMENT. OPERATION 2.Reinstall the wiring box cover. 3.Plug back the small connector inside the hood. 4.Reinstall the bottom plate, make sure both grease guides are aligned with the holes, install the grease pan. 5.Using long nose pliers.
MAINTENTANCE & CLEAN HOOD CLEANING 1.Disengage the grease pan from the hood body. preserve its fine appearance. Stainless steel is one of the easiest materials to keep clean. Occasional care will help 2.Disengage the small grease guard cups from the grease guard by turning counterclockwise and remove. Cleaning tips: * Hot water with soap or detergent is all that is usually needed. 3.Remove the screw retaining the grease guard to the hood. * Follow all cleaning by rinsing with clear water.