User Manual

- 17 -

USE
• If the apparatus is equipped with the
following controls luminous:
A = LIGHT
B = OFF
C = SPEED I
D = SPEED II
E = SPEED III
F = AUTOMATIC STOP TIMER - 15 minutes
(*)
• If your appliance does not have the
INTENSIVE speed function, press key E
for two seconds and it will be activated
for 10 minutes after which it will return
to the previously set speed. When the
function is active the LED flashes. To
interrupt it before the 10 minutes have
expired press key E again.
• By pressing key F for two seconds (with the hood switched o) the “clean air” function
is activated. This function switches the appliance on for ten minutes every hour at the
rst speed. As soon as this function is activated the motor starts up at the rst speed for
ten minutes, During this time key F and key C must ash at the same time.
After ten minutes the motor switches o and the LED of key F remains switched on with
a xed light until the motor starts up again at the rst speed after fty minutes and keys
F and C start to ash again for ten minutes and so on.
By pressing any key for the exclusion of the hood light the hood will return immediately
to its normal functioning (e.g. if key D is pressed the “clean air” function is deactivated
and the motor moves to the 2nd speed straight away. By pressing key B the function is
deactivated).
(*) The “automatic stop timer” delays stopping of the hood, which will continue func-
tioning for 15 minutes at the operating speed set at the time this function is activated.
• Active carbon/grease lter saturation:
- When button A flashes at a frequency of 2 seconds, the grease filters must be
cleaned.
- When button A ashes at a frequency of 0.5 seconds, the carbon lters must be
replaced.
After the clean lter has been replaced, the electronic memory must be reset by pressing
button A for approximately 5 seconds, until the light on the button stops ashing.