User Manual

- 15 -











�  
Fig.3: Put together the two parts
of the air deviator as shown in
picture no 3.1. It may be neces-
sary to cut the deviator to fit the
width of the chimney as shown
in picture 3.2. A sharp blade or
Hacksaw is recommended to
trim the plastic.
Fig.4: Take the air diverter A and drill two holes as
shown in the gure (hole diameter: 1/4" inches).
Once the two holes have been drilled, fasten the
air diverter A to the bracket H.
Fig.5: Fasten the air diverter
permanently to the wall with a
screw (the hole previously drilled
in Fig.2).
Fig.6: Once the air diverter has been inserted
into the bracket and fastened to the wall connect
the exible (6" ROUND FLEXIBLE METAL DUCT
PIPE NOT INCLUDED) pipe to the diverter, use
duct tape to seal.
6" ROUND
FLEXIBLE
METAL
DUCT PIPE NOT
INCLUDED