XOE30 XOE36 READ AND SAVE THE INSTRUCTIONS FOR RESIDENTIAL COOKING ONLY Register your product online at: www.xoventilation.
Dear Customer, If you follow the recommendations contained in this Instruction Manual, our appliance will give you constant high performance and will remain efficient for many years to come.
WARNING TO RUDUCE THE RICK OF FIRE, ELECTRIC SHOCK OR INJURE TO PERSONS, PLEASE OBSERVE THE FOLLOWINGS: length) 1. Installation work and electric wiring (including switch location) must be done by the qualified person(s) in accordance with local applicable codes and standards, including firerated construction. 2. This hood may have sharp edges. Be careful to avoid cuts and abrasions during installation and cleaning. 3.
WARNING - TO REDUCE THE RISK OF A RANGE TOP GREASE FIRE: 1. Never leave surface units unattended at high settings. Boilovers cause smoking and greasy spillovers that may ignite. Heat oils slowly on low or medium settings. 2. Always turn hood ON when cooking at high heat or when cooking flaming best capture of cooking impurities. 6. This hood is not intended to be used as a shelf. 7. Please read specification for further information and requirements.
2. Remove the bottom cover fixed in place with 3 screws. HOUSE WIRING 26"-32" ** Duct and roof cap/wall cap are not supplied. 3. Remove the Accessory parts box from inside of the hood. Warning: to avoid the risk of fire, use only the metal ductwork. NON-DUCTED VERSION 1.No need of plastic or metal duct. HOUSE WIRING 4.Non-ducted installation only Remove the Recirculation Plate out of the hood and use sealing plate (supplied in the accessory box) to seal the outlet off. 26"-32" 2.
2. Attach house power cable to hood using appropriate clamp. 3. Hold the hood in position under the cabinet. Tighten all 4 mounting screws completely to secure the hood to the cabinet. 5.Ducted installation only Tighten the Recirculation Plate and the outlet with screws. 4.For ducted installation, connect ductwork to hood and use duct tape to make joints secure and air-tight. Make sure the damper/duct connector enters ductwork and that the damper opens and closes freely. 5.
.Install the Halogen lamp. * Grease filters are washable. Remove the grease filters from the hood. Wash the filters, taking care not to bend them. Allow them to be dry before refitting. When refitting the filters, make sure that the handle is visible from the outside. Reinstall the grease filters to the hood. e e clockwis (2)Rotat (1)Push in 8.Replace the filters and turn on the power at service panel and test for proper operation.
