Manualshelf

Overlay Panel Ready Manual and Spec Sheet

ManualsBrandsXO ManualsBeverage Centers30 Inch French Door Wine Cellar + Beverage Center with 86 Cans/34 Bottles Capacity, Door Lock, Fan Circulation, UV Blocking Glass Door, Tri-Color LED Lighting, Digital Controls, Automatic Defrost, Carbon Air Filter, and Sabbath Mode: Panel Ready Overlay
11121314151617181920
+
+
LOCATE
SCREW
HOLES
2. Remove the rubber door gasket by pulling it gently out of the slot that holds it in place taking
care not to damage it. You will have to replace it later. This will expose the (6) screw attachment
holes.
3. Secure the overlay panel in place with clamps - use a soft non-slip pad between the jaws of the
clamp and the door and panel to prevent damage during clamping - DO NOT OVER TIGHTEN.
4. Strong tape may also be used to help prevent movement
of the panel during installation bu
t
be careful to ensure it will not damage the finish when removed - test a small inconspicuous area
first.
5. In the door frame, there are 6 screw attachment holes. Using a 7/64” drill bit, and the door
frame as a template - drill 6 pilot holes 7/16” deep into rear of the overlay panel. DO NOT drill
deeper than 7/16”.
7. Using the M4 screws supplied and a phillips head screwdriver install one M4 screw into each
hol
e and hand tighten until the head is snugged flush with the frame.
CAUTION: Do NOT over tighten as screws may strip out.
DOOR FRAME
OVERLAY
SCREW
If readjustment
is necessary -
loosen all 6 screws,
reposition the panel
and re-tighten
the screws.
Do Not Over-Tighten.
NOTE:
Actual screw hole
position may vary
according to model.
11
let’s face it
8. Remove clamps (and/or tape).
9. Push the rubber door gasket back into place
an
d re-assemble door back onto the hinges.
SCREW
LOCATIONS
If the door sags, loosen the two screws located on the bottom of the lower
hinge. With the door open, raise the handle side to level the door and re-tighten the screws.
(drawing shows screws in red as seen from below)
ADJUSTMENT
SCREWS