CONTENTS 1.Before Use How to Read this Manual Safety Warning Operation Precautions .Reset Device .Cleaning Device .Lens Fogging .Use of Disc .About Audio File .About Image File Calendar/Time Setup AVIN1/AVIN2 External Input U Disc/SD Card Function Operation Bluetooth Function Operation GPS Navigation Function Operation Other Function Operations .Back Rearview Function .About Video File 2.Basic Operation Panel Introduction Remote Controller Operation Turn the Unit On/Off Enter into the Main Interface 3.
Before Use How to Read This Manual This manual uses illustrations to explain its operations. The pictures shown in this manual are for reference only, the actual items are the standards. Marks Important precautions are described, please read carefully to prevent injuries etc. Special remarks, supplementary explanations, limitations and reference pages. Additional information to assist operation.
Before Use Warning To ensure your safety and the safety of your car and others, please make sure you follow the basic requirements below: Before using the unit, please read all the relative instructions carefully. Warranty does not apply to any damage caused by noncompliance with the instruction. To ensure driving safety and avoid breaking traffic regulation, please do not watch program or operate the unit while you are driving. Do not expose the unit to rainwater in case of short circuit.
Operation Precautions Additional Information Reset Device Use of disc If the unit or the connected unit fails to operate properly, press the reset hole with a pointed tool. The unit returns to factory settings after the unit is restarted. To obtain the best image and sound performance, please take the following precautions: 1. Do not touch the recording surface of the disc. 2. Do not stick tape etc. on the disc, or use a disc with tape stuck on it. 3. Do not use CD type accessories. 4.
Operation Precautions Additional Information Video Section Color System of External Video Input NTSC/PAL External Video Input Level (RCA jacks) 1 Vp-p/75Ω Audio Section Maximum Power (Front & Rear) 40W X 4 Full Bandwidth Power (Front & Fear) (＜1% THD) 22W X 4 Speaker Impedance 4Ω General Operating Voltage 14.4V (10.
Additional Information Operation Precautions Specification About Audio File Playable Audio File MP3(. Mp3)、 WMA(.wma) Playable MP3 File Format: MPEG 1/2 Audio Layer 3 file Transmission Bit Rate: 24-320kbp/VBR Sample Rate: 8, 11.025, 12, 16, 22.05, 24, 32, 44.1, 48kHz ID3 Labels: Version1.0, 1.1, 2.2, 2.3, 2.
Basic operation of setup menu Foreground/background Setup You can enable background mode by foreground/background setup. When the unit is connected with background device, you can enable background mode of the unit to play audio and video files. Touch [Setup] icon in the main interface. Enter into setup interface. Touch [Foreground/background] icon. Enter into foreground/background setup interface. Radio Area Setup You need to select your radio area before you use radio function.
Operation Precautions About Video File Acceptable Video File MPEG1、MPEG2、DivX Acceptable MPEG-1 File Extended Name: .mpg,.mpeg,.mpe, .m1v Image Size: 320x240、352x240 Audio Format: MPEG Audio Layer 2 Audio Sample Rate: 32/44.1/48kHz Audio Bit Rate: 32-320kbps (Constant bit rate only) Acceptable MPEG-2 File Extended Name: .mpg, .mpeg, .m2v Image Size: 640x480|704x480 Audio Format: MPEG Audio Layer 2 Audio Sample Rate: 32/44.
Basic operation of setup menu Basic Operation Sound Setup Panel Introduction Touch [Sound Setup] icon to enter sound setup interface as is shown below: TFT-OFF RP T OPEN CAR DVD/CD/MP3/MP4 PLAYER IR SRC REL MIC DVD FM/AM AUX Sound effect setup: select general, pop, classic or rock, you can adjust to the best audio effect according to your preferences.
Basic Operation Basic operation of setup menu Touch Screen Calibration If errors occur in touch position, you can calibrate touch coordinates. Touch [Setup] icon in the main interface. Enter into setup interface. Switch page, touch [Touch Calibration] icon. Enter touch calibration interface. Perform calibration with a touch pen. Touch method: Use a touch pen to click the central area of symbol “+”, calibrate the screen in the moving sequence of the central area of “+”.
Function Operation Basic operation of setup menu Other Functions Navigation Path Setup CCD system (back rearview function) During back, if your rearview mirror device has been connected, after the car is put in reverse, system automatically switches to the rearview mirror function screen and display the back scene video shot by your rearview mirror. Navigation path is already set when you buy the product. Do not enter into the navigation setup interface to change path arbitrarily.
Basic Operation Function Operation Remote Controller Operation GPS Navigation Function Operation 1.PWR Press the button to turn the power on/off. 2.MUTE Press the button to turn the volume output on/off, repress it to resume previous volume level. 3.NAVI Press the button to enter/exit the navigation interface. 4.SOURCE/IR-SW---mode switch Short press the button to switch the mode. Long press the button to switch between foreground/background controls for the remote controller.
Function Operation Basic Operation Receive a call In any mode, when a call arrives, system will automatically switch to bluetooth function interface, and switch from speaker to phone ring. Touch button in the bluetooth interface to answer a call; touch button to refuse a call. 14.ST/PROG---stereo/programmed playback In radio mode, press the button to select stereo or mono station; in playback status, work with number buttons to start programmed playback. 15.
Basic Operation Function Operation Turn the unit on/off On When the ignition switch is turned to the ACC or ON position, press button on the panel to turn the unit on. Off After the unit is started, hold button for 3 seconds or more to turn the unit off. After the unit is started, turn the ignition switch to the LOCK position or take out the key, the unit will turn off automatically. Next time the ignition switch is turned to the ACC or ON position, the unit will turn on automatically.
Function Operation Function Operation U Disc/SD Card function operation When there is a USB device/SD card connected, the unit can conduct the playback of audio/video/image files in the USB device/SD card. 1. This operation is only effective when the unit has USB connectors. 2. The unit only supports U discs/SD cards with memories less than 8G. Insert/Eject USB storage device 1. Connect a U disc recorded with media information to the unit by a USB connecting cable. 2.
Function Operation Function Operation Calendar/time setup Disc Function Operation 1.AF Touch the button to turn the AF function on/off. When the received station signals become weak, the radio will automatically fine-tune to other frequencies. When receiving an emergency announcing, the screen will display warning message “ALARM“. Receive traffic information ①Press [TA] button to open TA mode. ② When the traffic station is turned on, the radio will automatically search for traffic stations.
Function Operation Function Operation 3.3 Disc select menu language Select a language (which the disc supports) for the menu. 3.4 Age control You can directly click song name to select and play, you can also click the numeric keypad button and enter song number to selected your favorite song to play. Select to start the code mode. During playback of disc, touch the middle lower area of the screen to pop up the touch menu, operate the touch menu to perform various playback controls.
Function Operation Stop Touch the button to enter into prestop status, and then touch to continue to play. Double touch button to enter into completely stop status, then touch button to restart playing in the song sequence of disc. Function Operation See detailed DVD title information. If the DVD is recorded in 16:9 ratio and the image is set in 4: 3 display, then the image will be horizontally compressed when it is displayed.
