In-Dash Car RDS/FM Radio, MP3 Player With USB/SD Card Inputs Car Single-DIN Mech-less Series Model No.
CONTENTS Precautions..................................................................................................................1 Precautions & Warnings..............................................................................................1 Lithium Battery Cell Warnings.....................................................................................1 Drivers and Connections.............................................................................................1 Other Warnings..........
PRECAUTIONS Precautions & Warnings • • • • • • • • To reduce the risk of fire, electric shock, and interfer-ence, do not attempt to repair this unit yourself. Refer all service to a qualified technician. Some MP3/WMA files may not be playable. Keep the volume at a reasonable level to avoid distracted driving. High volume levels may make it difficult to concentrate on traffic and road conditions while driving.
INSTALLATION Installation Procedures First complete the electrical connections and then check for correctness. Installation Opening This unit can be installed in any dashboard Having an opening as shown the right figure. 53 mm 182 mm To Install the Car Radio Be sure you test all connections first, and then follow these steps to install this unit. 1. Make sure the ignition is turned off, and then disconnect the cable from the vehicle battery’s negative (-) terminal. 2.
INSTALLATION(CONT.) 8. Make wiring connections, as illustrated in the “Wiring Diagram.” 9. Install the plastic outer trim ring. - Only use speakers with 4 ohms impedance. - Do not attach the control panel to the chassis before wiring is complete. - The maximum current of the auto antenna is 200mA. Wiring Connections WIRING DIAGRAM CAUTION +12V DC NEGATIVE GROUND Removal of the Main Unit 1. Remove the plastic trim out from the main unit. 2.
CONTROL PANEL BUTTON LOCATIONS XM-RSU254BT PTY 17 18 19 1. (power)/SRC (source) button 2. SEL (select/menu) button and VOL (volume) knob 3. BND(band) button, AMS (automatic music search) button, button 4. (pause/play), Preset station1 button 5. INT (intro) , Preset station 2 button 6. RPT (repeat) , Preset station 3 button 7. RDM (random) , Preset station 4 button 8. -10(previous 10 tracks) , Preset station 5 button 9. +10(next 10 tracks) , Preset station 6 button 10.
GENERAL OPERATION Turn Unit On/Off • Press the power ( ) /SRC button on the front panel to turn on the unit. • Press and hold the power ( ) / SRC button to turn off the unit. Adjust Volume (VOL) Rotate the VOL knob on the front panel or press the VOL+ control to increase or decrease the volume level.
GENERAL OPERATION (CONT.) - TA VOL (traffic announcement volume): This function allows you to define the minimum volume for the traffic announcements. The adjustable range is 0~43. The defaulted value is 26. Rotate the VOL knob to adjust the volume of the traffic announcements. - REG ON/OFF: Enables or disables the region mode. Some broadcasting stations change their program from normal broadcasting to regional broadcasting for a certain time period.
RADIO OPERATION Change Bands (BAND) Press the BAND button to switch between the FM1, FM2, FM3 bands. Each band stores up to six preset stations. Manual Tuning ( / ) Press and hold the or button on the front panel or on the remote control to enter manual tuning mode. In manual tuning mode, press the or button to move the radio frequency number up or down one step.
USB / CARD OPERATION To insert USB / Micro SD CARD • To play files on a USB device or an micro SD card, open the USB port cover and insert the USB storage device into the USB port or insert an micro SD card into micro SD card slot. Playback will begin automatically. XM-RSU254BT PTY Eject USB/Micro SD • To eject a USB device, press the button to stop playback, then remove the USB device.
USB / CARD OPERATION (CONT.) c) After selecting the desired serial number of your favorite song, press the SEL button to confirm and search. The track will be played immediately when the number is matched. eg.: You want to listen to the 123th song. - Rotate the VOL knob to select the “1” on the ones place, 2 seconds later, the “1" will skip to tens place.
BLUETOOTH OPERATION Pair and Connect Prior to using the Bluetooth device as a handsfree system for a Bluetooth-enabled mobile phone for the first time, you must pair and connect the two devices as follows: 1. In any mode, prior to pairing and connecting, the BT logo in the LCD indicating that no device is connected. To begin pairing, enable BT mode on your mobile phone. 2. When the phone the car audio system,the XOMAX XM-RSU254BT name will be displayed. 3.
REMOTE CONTROL Remove Insulating Sheet The remote control comes with an insulating sheet attached to the underside of the remote control, as illustrated on the right. The remote control will not work until the insulating sheet is removed. Replace Lithium Battery Cell 1. When the lithium cell battery becomes weak, replace it as illustrated on the right. 2. Press and hold the movable block in the direction indicated by arrow 1.
SPECIFICATIONS General Chassis Dimensions...............................................................178(W) x 108(D) x 50(H) mm Power Supply Requirement ..................................................................................DC 12V Current Consumption ................................................................................................10A Maximum Power Output ........................................................................... W x 4CH Radio FM Frequency Range........
TROUBLESHOOTING lfyou suspect something is wrong immediately switch power off.Do not use the unitinabnormal condition,for example without sound, orwith smoke orfoul smell,can cause fire or electric shock lmmediately stop using it and call the store where you purchased it.Never try to repairthe unit yourself because it is dangeraus to do so. • General Nopoweror no so und Car's engine switch is not on. Turn your car's key to ACC or ON. Gableis not correctly connected. Check connection. Fuse is burnt.
