XM-VRSU727BT INSTALLATION MANUAL PAIR BND MU/PTY TA/AF CAR AUDIO/VIDEO SYSTEM 7 Inch Million Multi-color Illumination TFT Touch Screen Detachable Control Panel Remote Control Control Panel USB Port and AUX Input Memory Card Slot AM/FM-RDS Digital PLL Tuning Radio BT A2DP & AVRCP Support
To ensure safety while driving and to comply with laws, drivers should not watch video or operate the video device while driving.
Precaution THANK YOU FOR PURCHASING A SOUNDSTORM MULTIMEDIA PLAYER . Before operating the unit, read this manual thoroughly and keep it handy for future reference . To avoid injury or accident , read the following precautions before installing and operating the unit . ON INSTALLATION DO NOT install any receiver in locations where; - it may obstruct the steering wheel and gearshift lever operations, as this may result in a traffic accident.
Installation NOTES: Choose the mounting location where the unit will not interfere with the normal driving function of the driver. Before finally installing the unit, connect the wiring temporarily and make sure it is all connected up properly and the unit and the system work properly. Use only the parts included with the unit to ensure proper installation. The use of unauthorized parts can cause malfunctions.
Installation Installating the unit DASH BOARD METAL MOUNTING STRAP HEX NUT SPRING WASHER PLAIN WASHER CONSOLE TAPPING SCREW SLIDE BRACKET HOUSING HEX BOLT SCREWDRIVER TABS KEY PLATE PLASTIC TRIM OUT KEY PLATE If you want to take CHASSIS out of the SLIDE BRACKET HOUSING, first remove the PLASTIC TRIM OUT of the both sides away, then insert the two KEY PLATE into left and right side of chassis as above illustration.
Electric Connection WIRING CONNECTION RCH IN RED AV IN SUBWOOFER GREY VIDEO OUT(2) YELLOW REAR CAMERA INPUT YELLOW VIDEO IN YELLOW RCA OUTPUT CABLE LCH IN WHITE FRONT RCA RED R VIDEO OUT YELLOW FRONT RCA WHITE L RADIO ANTENNA JACK ISO CONNECTOR IGNITION SWITCH(B+) MEMORY BACK-UP(B+) GROUND(B-) RED KEY GROUND(BLACK) FUSE KEY 1(BROWN) YELLOW KEY 2(WHITE 25$1*() BLACK AUTO ANTENNA FRONT LCH SPK. REAR LCH SPK.
Remote Control 1. OPEN/ BUTTON 12. MENU/4BUTTON 2. MODE BUTTON 13. VOL - BUTTON 3. >> BUTTON 14.SEL BUTTON 4. AS/ 15.MUTE BUTTON BUTTON 5. >II BUTTON 16. BAND/ 6. I<< BUTTON 17.>>I BUTTON 7. << BUTTON 18. EQ BUTTON 8. TITLE BUTTON 19. RDM/3 BUTTON 9. RPT/2 BUTTON 20. SUB-T/6 BUTTON 10. DISP/1 BUTTON 21. VOL + BUTTON 11.
Remote Control Preparing the Remote Control Inserting the Battery 1.First push to inside as the direction indicated by the arrow (See 1 )And then Remove the battery holder as the direction indicated by the arrow (See 2 ). 2.Replace the battery Set a new battery property with (+)side up as illustrated (See 3 ). 3.Insert the battery holder. Push in the holder to the original position(See 4 ).
Basic Operation Touch the “ ” ICON on screen to turn the unit off . Press the“ ” onthe front panel to turn It on, press it again to turn off . FIG.3 OPEN/CLOSE MONITOR AND ANGLE ADJUSTMENT Press OPEN button on front panel, the monitor will draw out automatically . Do not rotate the monitor forcibly to avoid mechanical damage .FIG.4 FIG.1 OPEN/CLOSE button When the monitor draws out to a certain location, it will turn upward automatically and stop at vertical position .
Basic Operation Main Menu Operation GENERAL CLOCK In many modes, touch the icon or touch the range to enter the main menu, the message like following as below. AUDIO VIDEO Setup interface 1 (1) LANGUAGE ILLUMINATION COLOR CALIBRATION Setup interface 2 (2) (4) (3) (5) (6) (7) 1. When the unit is power on, tap to turn off the display and the unit still work, tap anywhere of the display to turn on the display again. 2. POWER icon In any modes, touch the POWER icon to switch the unit off .
Basic Operation Disc setup as follow: RATING Select to turn Parental Control on or off. The factory default password is 1234. (The password must be used to make changes to the Parental Control menu below .) DISC FORMAT AUTO TV TYPE 16:9 RATING ADULT FORMAT This player is capable of playing discs recorded in either PAL or NTSC formats. Make the selection based on whether you are connecting the unit to a PAL TV or an NTSC TV. You can also set the unit to AUTO (auto select).
Basic Operation AUDIO SETUP Touch the audio to turn to audio quality adjustment. VIDEO SETUP COLOR 20 BRIGHTNESS 20 CONTRAST 20 TINT 20 AUDIO BASS TREBLE SUBWOOFER ... EQ USER Video setup interface audio setup interface1 AUDIO LOUDNESS OFF FADER/BALANCE COLOR: 0 to 40 Adjust the color for the picture-lighter or darker. ... BRIGHTNESS: 0 to 40 Adjust if the picture is too bright or too dark. audio setup interface2 TREBLE: -7 to +7 Adjust treble level .
Basic Operation CALIBRATION Touch the arrow as show to calibration the display. Reset Factory Settings RESET button is placed on the housing and must be activated with either a ballpoint pen or thin metal object. SD RESET RESET The RESET button is to be activated for the following reasons: A. Initial installation of the unit when all wiring is completed. B. All the function buttons do not operate. C. Error symbol on the display.
Control Panel UNIT KEYS 11 PAIR BND 2 10 16 3 6 TA/AF MU/PTY 9 5 7 4 15 1 12 8 SD RESET 13 14 1. OPEN BUTTON To slide the monitor out and stand it up or into the monitor slot, press this button; 2. VOL KNOB & SEL BUTTON In normal mode, the VOL knob is used to increase or decrease the volume. Press the SEL(in radio mode,press and hold the SEL) to switch between BASS,TREBLE,BALANCE, SWF VOL, SWF FREQ.
Control Panel 4/9. >>|/ and |<>| button can automatically search down or up for an available station beginning from the current frequency; Briefly pressing |<< or >>| button can manually search down or up for a your desired station beginning from the current frequency.
Control Panel 8. REL BUTTON Press it to detach the control panel. 10. IR sensor 11. USB PORT 12. AUX IN JACK 13. SD CARD SLOT 14. RESET BUTTON Press this button to return to factory settings. 15 . TA/AF BUTTON TA Function [traffic Announcement] Button(for Rds Only) In RADIO mode When you swing briefly the MU/PTY knob in the direction of the TA/AF button , the TA function is activated, the TA symbol appears in the display . (swing it again to turn off .
Touch Screen Operation RADIO OPERATION Briefly touch “ ” to decrease frequency by one step of channel spacing. Listening to Radio Touch the RADIO ICON in home menu to enter the RADIO mode. In radio mode, tap icon to adjust the brightness for the display . Automatic Search During Radio mode, touch and hold (for more than 2 seconds ) either “ / ” ICONS to start search for a radio station automatically.
Touch Screen Operation Automatic Memory Storing & Program Scanning Automatic Preset Setup In Radio Mode, touch and keep (for more than 2 ’ S) the screen of “ ” range to active automatic station storage. The radio searches within the current frequency band, e.g. FM 3 , for the stronger signal level until the search cycle has finished . The six strongest stations are then allocated to the corresponding storage locations . Then the station of the first storage location is set .
Touch Screen Operation Touch the AF section on touch screen or swing and keep the SEL knob in the TA/AF direction for about 2 seconds , the AF function is activated. The AF symbol appears in the display . PI MUTE : the sound of another station is suppressed . TA Traffic Announcement (Priority For Traffic Information) When the AF function has been switched on, the radio continuously tests the signal strength of the AF frequency .
Touch Screen Operation BASIC OPERATION Pause (still picture) Touch the “ ” section on touch screen during playback will stop play temporary, touch it again to return the normal playback . on on the remote control to play in random. Each play mode the order is different . Touch it again to cancel this function . Note : in random mode, the button is not available .
Touch Screen Operation BT Operation 1.
Touch Screen Operation Tap a icon such as to show as follow: : Tap to download the contacts from your phone. CONTACTS : Tap for phone number search. & : For page turning. b. Use the number icons to input your desired phone number; * When inputting a wrong digit, use c. After finishing inputting, touch to dial out. icon or < button to delete it. icon or press button on control panel 2) Redial last dialed phone number Touch icon to dial out the last dialed phone number.
Touch Screen Operation 3 . BT MUSIC 1 ) Touch BT MUSIC in home menu or pressing MODE button can pop up BT MUSIC interface as follows: Mute function Play/Pause the playing To select the Equalizer mode To skip the next track To decrease the volume level To skip the previous track To increase the volume level Tap to turn to BT PHONE mode. Loudness Function (After pairing and connecting a phone with BT function).
Touch Screen Operation AUX Operation On the front panel of this unit, there is an AUX IN jack, follow the diagram below to connect analogue replay devices(only for the Audio connect, if you want to connect the Video, please plug the
Touch Screen Operation AV Operation Please plug the
Touch Screen Operation USB OPERATION Card OPERATION Following the diagram below, connect your USB device to the front panel USB port . If it is properly connected, the device will be mounted and start playing automatically. The unit can support playback MP3/WMA/ JPEG/MP4 format which are stored on SD memory cards . Please read the following instructions before you start using a memory card .
Touch Screen Operation STEERING WHEEL CONTROL Touch the SWC icon as follow to turn to steering wheel control . Then tap Assign and tap the button 1 and then select the icon as the picture show, the icon show in button 1 position. After selection tap confirm and back to home menu that means select finish. The function of the icons as follow: Touch to begin function save. After selection touch to confirm operation. During setting, touch the turn to home menu.
Specification General Power Supply Requirement..................................................DC 12V Current consumption........................................................10A MAX. Audio Signal Output ............................................................ 2ch&4ch line out Frequency Response................................................... 20 Hz - 20 KHz S/N Ratio ........................................................................... 90 dB (JIS) Wow and Flutter ............................
