Operation Manual

HMT 300 31
English
FIRST STEPS
To en/disable the device press either the button on the frontside of the device or on the remote
control.
Before using the HMT 300, the following requirements are needed:
 A broadband connection in combination with a wired/wireless access point, router or
similar network device.
 The network device needs to support WIFI (802.11b/g/n) wireless connection.
 A PC or smart phone with a network ready. This network has to be the same one as the
HMT 300 equipped with.
Erstinbetriebnahme
When it is first time running the XORO HMT 300 device, the system will ask you to set Language and
Network Configurations. Rotate the rotary button and select your favorite language pressing the
rotary button [Enter]. Answer if the device should connect automatically to known networks. After
that, you can connect with your network. If you answer „Yes“, the display goes to scanning for Wire-
less Network and shortly afterwards a list of available wireless networks will appear.
Enter the password using the buttons on the device. Note the use of upper and lower case when
entering the password.
[Left] = Go to previous entry space
[Right] = Go to next entry space
DOWN/UP = Select number/letter
Enter = Confirm entire entry
Getting Started
Network Requirements and Power On/Off