Operation Manual

English

USB connection

The TV requires possibly some time until the USB storage device is fully loaded and ready for use.

Remove the USB device only when all the recordings or reproductions are completed.

The USB ports on this device are not suitable for charging devices with an integrated battery (eg

mobile phones, tablet computers, MP3 players, etc.). Note the information regarding on the namepla-

te and the maximum current output of the USB ports.

Notes:

 USB mass storage to 750 GB are supported. Memory devices with greater capacity can be

used, however, the compatibility can not be guaranteed under all circumstances to the TV.

 A wide variety of USB storage devices will be sold at the time, possibly not all the relevant

specifications for USB mass storage devices. If your are not recognized by my TV USB stora-

ge device, please try another USB storage.

 Should no longer be recognized a USB device, perform with the help of your computer a disk

diagnosis or reformat the USB storage device again.

 USB devices that require more current than 500mA (0.5A), violate the USB specification and

may not work flawlessly together with the television.

 Always backup all data from the USB memory before you connect it to the TV.

 For the recording of HD broadcasts or use the Timeshift function sufficiently fast USB storage

device is needed.

packaging content

The following components are supplied with the Xoro HTC / HTL Television:

 HD Television

 Remote

 User manual

 power Supply (for devices with external power supply)

 Adapter cable

 Stands

If any of these items are missing, please contact your dealer as soon as possible. Keep the original

packaging in the event that the unit must be returned to the dealer.

Inserting the batteries

 Open the battery compartment on the lower back of the remote

 Insert the batteries into the compartment. Please

pay attention when inserting the battery to the

correct polarity (+/-).

 Slide the battery cover back on (Figure).

Notes:

 Always point the remote control at the sensor array (IR) of the equipment.

 The distance to the device should not be more than 5 meters and is not the operation angle is

greater than 60 °.

 Remove the batteries from the remote control when not using the unit for a long time.

Safety instructions