Operation Manual

26
English
For the column of the tuning following configuration options are available:
LNB Typ define the oscillator frequency for your LNB . Please take the correct value from the
manual of your LNB (standard:09750/10600)
LNB Voltage This parameter defines the storm voltage of the antenna, and signal from horizontal
or vertical polarized transponder will be received. The setting will only have to be
changed in very rare cases. A false setting will result in missing program or no signal
reception at all. (standard: On)
22KHz The receiver can switch the LNB with 22 KHz signals for the reception of another
frequency band. The setting will only have to be changed in very rare cases. A false
setting will result in missing program or no signal reception at all. (standard: Auto)
Toneburst Tone burst switcher has two input ports, enabling the connection of 2 antennas or
LNB to the receiver. If you have a Tone burst switcher, you will have to select one of
the both connections (A or B) for the satellite chosen on the left side.
DiSEqC DiSEqC switcher has up to 16 input ports enabling the connection of multiple anten
nas or LNB to the receiver. If you have a DiSEqC switcher, you will have to select one
of connections for the satellite chosen on the left side. Please check which version
(1.0, 1.1) could be supported in the manual of your switcher.
Motor Rotatable Antennas require extended configurations. We recommend professional
installation from a technician. Please set up according to your antenna.
Use a Unicable reception system, please proceed as follows:
 Navigate in the manual tuning to the right column to the menu item LNB type and press the
OK button.
 Select from the list at the bottom of the option Unicable and press the OK button to make
further adjustments to your Unicable reception system:
LNB high / low Define the frequency range for your Unicable LNB. No changes need
to be made here normally.
User ID Each receiver in a single-cable reception system must be assigned a
user ID. Most systems are designed for 4 or 8 receivers. It is im
portant to ensure that only one receiver is assigned a user tape. Uses
more than one receiver, the same user ID, it comes to function
disorders. Other, incorrectly Receiver can cause the reception of the
equipment is impaired.
Frequenz Each user band is a frequency band associated with that you must
set in this menu item, each user on each band.
Notes:
 Please ask the installer of your reception system, which are user band and what frequency
band available to you. In the documents relating to your reception system, this information
should be also be found.
 Note that all components of your receiving system for the cable system must be compatible.
Main menu