User's Manual

8 English
ITE power adapter precautions
• Use only the AC adapter and power cord approved for this Tablet PC
or Tablet PC accessory. Use of another type of AC adapter may risk
fire or explosion.
• Place the AC adapter in a ventilated area, such as on a desktop or the
floor, when you use it to run the Tablet PC or to charge the battery.
Do not cover the AC adapter with papers or other items that will
reduce cooling; also, do not use the AC adapter while it is inside a
carrying case.
• Be sure that nothing rests on the AC adapter’s power cable and that
the cable is not located where it can be tripped over or stepped on.
• Disconnect power cords and cables by grasping the connector, not
by pulling on the cable itself. As you pull out the connector, keep it
evenly aligned to avoid bending any connector pins. Before you
connect a cable, make sure both connectors are correctly aligned.
For information about the medical power adapter, see “Medical power
adapter precaution” on page 8.
Medical power adapter precaution
Additional equipment connected to medical electrical equipment must
comply with the respective IEC or ISO standards (e.g. IEC 60950-1 for
data processing equipment). Furthermore, all configurations shall
comply with the requirements for medical electrical systems (see IEC
60601-1 or clause 16 of the 3Ed. of IEC 60601-1, respectively). Anybody
connecting additional equipment to medical electrical equipment
configures a medical system and is therefore responsible that the system
complies with the requirements for medical electrical systems. Attention
is drawn to the fact that local laws take priority over the above
mentioned requirements. If in doubt, consult your local representative or
the technical service department.
Standard / directive references:
• IEC/EN 60601-1+A1+A2: 1995: 6.8.2.c, 19.2.b, 19.2.c
• IEC 60601-1: 2006: 7.9.2.5
• MDD 93/42/EEC: Annex 1 clause 13.6.c
• UL 60601-1, first edition
• CAN/CSA C22.2 No. 601-1, first edition