User's Manual

OPERATION
To initiate the RDA-100, first refer to safety precautions on page 4.
• 1. Plug unit in to a standard three prong 110v power cord (MUST HAVE GROUND TERMINAL).
• 2. Insert key into the system key switch (Item# 5) and turn the key clockwise.
• 3. Turn the green on/off switch (Item# 6) clockwise to arm system (switch will illuminate green if plugged into
110v power outlet).
• 4. The Red 12v power light (Item# 7) will then illuminate indicating that the system is on.
• 5. Wait approximately 1 minute before logging in to allow radios to connect.
• 6. Once radios have initiated you may scan for the wireless device (motion) and enter the default password
(1234554321).
NOTE: When running off of the internal battery only, the RDA-100 has an on board protection system that
will shut the system down before the batteries run completely flat. When this happens, the unit must be
plugged in to a power source until the battery is charged. The system will automatically reboot itself when
it reaches the proper voltage.
Warning: The internal antenna’s must have a separation of at least 30 Centimeters from all persons during
normal operation.