User's Manual

Appendix E. Agency Notices
XC6 User’s Handbook 82
RF exposure
Tests for SAR are conducted using standard operating positions specified by the
FCC with the tablet PC transmitting at its highest certified power level in all
tested frequency bands. Although the SAR is determined at the highest certified
power level, the actual SAR level of the tablet PC while operating can be well
below the maximum value. This is because the tablet PC is designed to operate at
multiple power levels so as to use only the power required to reach the network.
In general, the closer you are to a wireless base station antenna, the lower the
power output.
Before a tablet PC model is available for sale to the public, it must be tested and
certified to the FCC that it does not exceed the limit established by the
government-adopted requirement for safe exposure. The tests are performed in
positions and locations (e.g., on the body) as required by the FCC for each model.
(Body-worn measurements may differ among tablet PC models, depending upon
available accessories and FCC requirements). While there may be differences
between the SAR levels of various tablet PCs and at various positions, they all
meet the government requirement for safe exposure.
This device was evaluated and shown to comply with FCC SAR guidelines.
Avoid covering or holding antennas when transmitting. Antenna locations are
shown in the following figure.
Antennas
Bluetooth
antenna