Installation Instructions

5-35
Cisco Aironet Wireless LAN Client Adapters Installation and Configuration Guide for Windows
OL-1394-06
Chapter 5 Configuring the Client Adapter
Setting Network Security Parameters
Step 1 Select Host Based EAP from the Network Security Type drop-down box on the Network Security
screen.
Step 2 Select Use Dynamic WEP Keys under WEP.
Step 3 Click OK to return to the Profile Manager screen.
Step 4 Click OK or Apply on the Profile Manager screen to save your changes.
Step 5 Perform one of the following, depending on your computer’s operating system:
• If your computer is running Windows 98, 98 SE, NT, or Me, run the Microsoft 802.1X
Authentication Client application. Then go to Step 7.
• If your computer is running Windows 2000, double-click My Computer, Control Panel, and
Network and Dial-up Connections. Right-click Local Area Connection. Click Properties. The
Local Area Connection Properties screen appears.
• If your computer is running Windows XP, double-click My Computer, Control Panel, and
Network Connections. Right-click Wireless Network Connection. Click Properties. The
Wireless Network Connection Properties screen appears.
Note These instructions assume you are using Windows XP’s classic view rather than its category
view.
Step 6 Click the Authentication tab. The following screen appears (see Figure 5-7).
Note In Service Pack 1 for Windows XP, the Authentication tab has moved from its previous location.
To access it, click the Wireless Networks tab, select the network that you are configuring in the
Preferred network list, and click Properties.