Installation Instructions

5-36
Cisco Aironet Wireless LAN Client Adapters Installation and Configuration Guide for Windows
OL-1394-06
Chapter 5 Configuring the Client Adapter
Setting Network Security Parameters
Figure 5-7 Wireless Network Connection Properties Screen (Authentication Tab) - Windows 2000 and
XP Only
Step 7
Check the Enable network access control using IEEE 802.1X check box.
Step 8 Perform one of the following, depending on the authentication type you want to use:
• If you are planning to use EAP-TLS, go to the “Enabling EAP-TLS” section below.
• If you are planning to use PEAP, go to the “Enabling PEAP” section on page 5-39.
• If you are planning to use EAP-SIM, go to the “Enabling EAP-SIM” section on page 5-41.
Enabling EAP-TLS
Follow the steps below to enable EAP-TLS.
Step 1 For EAP type, select Certificates (on Windows 98, 98 SE, NT, or Me) or Smart Card or other
Certificate (on Windows 2000 or XP).
Step 2 Click Properties. The Certificate Properties screen (see Figure 5-8) or the Smart Card or other
Certificate Properties screen appears (see Figure 5-9).