Installation Instructions

5-8
Cisco Aironet Wireless LAN Client Adapters Installation and Configuration Guide for Windows
OL-1394-06
Chapter 5 Configuring the Client Adapter
Setting RF Network Parameters
Table 5-3 lists and describes the client adapter’s RF network parameters. Follow the instructions in the
table to change any parameters.
Table 5-3 RF Network Parameters
Parameter Description
Data Rate Specifies the rate at which your client adapter should transmit or
receive packets to or from access points (in infrastructure mode) or
other clients (in ad hoc mode).
Auto Rate Selection is recommended for infrastructure mode; setting a
specific data rate is recommended for ad hoc mode.
Options: Auto Rate Selection, 1 Mbps Only, 2 Mbps Only, 5.5 Mbps
Only, or 11 Mbps Only (2.4-GHz client adapters);
Auto Rate Selection, 6 Mbps Only, 9 Mbps Only, 12 Mbps
Only, 18 Mbps Only, 24 Mbps Only, 36 Mbps Only, 48 Mbps
Only, or 54 Mbps Only (5-GHz client adapters)
Default: Auto Rate Selection
Data Rate
Description
2.4-GHz Client
Adapters
5-GHz Client
Adapters
Auto Rate
Selection
Auto Rate
Selection
Uses the 11-Mbps (for 2.4-GHz client
adapters) or 54-Mbps (for 5-GHz client
adapters) data rate when possible but
drops to lower rates when necessary.
1 Mbps
Only
6 Mbps
Only
Offers the greatest range but the lowest
throughput.
2 Mbps
Only and
5.5 Mbps
Only
9 Mbps
Only to 48
Mbps Only
Progressively offers less range but greater
throughput than the 1 Mbps Only (for
2.4-GHz client adapters) or 6 Mbps Only
(for 5-GHz client adapters) option.
11 Mbps
Only
54 Mbps
Only
Offers the greatest throughput but the
lowest range.
Note Your client adapter’s data rate must be set to Auto Rate
Selection or must match the data rate of the access point (in
infrastructure mode) or the other clients (in ad hoc mode) with
which it is to communicate. Otherwise, your client adapter may
not be able to associate to them.