User Manual

3-21
Cisco Aironet Wireless LAN Client Adapters Installation and Configuration Guide for Windows
OL-1394-06
Chapter 3 Installing the Client Adapter
Installing or Upgrading the Client Adapter Software
Figure 3-7 Microsoft TCP/IP Properties Screen
Step 23 On the IP Address tab, find and select the client adapter that you are installing under Adapter.
Step 24 Perform one of the following:
• If your computer is connected to a DHCP server, select Obtain an IP address from a DHCP server.
When asked if you want to enable DHCP, click Yes and OK.
• If your computer is not connected to a DHCP server and you plan to use TCP/IP, select Specify an
IP address and enter the IP address, subnet mask, and default gateway address of your computer
(which can be obtained from your system administrator). Click OK.
The installation process begins, and you are notified as each component is installed.
Step 25 Windows NT must be rebooted in order for your changes to take effect. Click Yes when a message
appears asking if you wish to reboot now.
Caution To prevent unpredictable results, Cisco recommends that you click Yes to reboot your computer now.