Quick Start Guide

FCC Statement

This equipment has been tested and found to comply with the limits for a Class B

digital device, pursuant to part 15 of the FCC Rules. These limits are designed to

provide reasonable protection against harmful interference in a residential installation.

This equipment generates, uses and can radiate radio frequency energy and, if not

installed and used in accordance with the instructions, may cause harmful interference

to radio communications. However, there is no guarantee that interference will not

occur in a particular installation. If this equipment does cause harmful interference to

radio or television reception, which can be determined by turning the equipment off

and on, the user is encouraged to try to correct the interference by one or more of the

following measures:

• Reorient or relocate the receiving antenna.

• Increase the separation between the equipment and receiver.

• Connect the equipment into an outlet on a circuit different from that to which the

receiver is connected.

• Consult the dealer or an experienced radio/TV technician for help.

Caution: Any changes or modiﬁcations to this device not explicitly approved by

manufacturer could void your authority to operate this equipment.

This device complies with part 15 of the FCC Rules. Operation is subject to the

following two conditions: (1) This device may not cause harmful interference, and (2)

this device must accept any interference received, including interference that may

cause undesired operation.

Specific Absorption Rate (SAR) information:

This 4G SMARTPHONE meets the government's requirements for exposure to radio

waves. The guidelines are based on standards that were developed by independent

scientific organizations through periodic and thorough evaluation of scientific studies.

The standards include a substantial safety margin designed to assure the safety of all

persons regardless of age or health. FCC RF Exposure Information and Statement the

SAR limit of USA (FCC) is 1.6 W/kg averaged over one gram of tissue. Device types:

4G SMARTPHONE has also been tested against this SAR limit. This device was

tested for typical body-worn operations with the back of the phone kept 10mm from

the body. To maintain compliance with FCC RF exposure requirements, use

accessories that maintain an 10mm separation distance between the user's body and

the back of the 4G SMARTPHONE. The use of belt clips, holsters and similar

accessories should not contain metallic components in its assembly. The use of

accessories that do not satisfy these requirements may not comply with FCC RF

exposure requirements, and should be avoided.