PLEASE READ AND SAVE THESE INSTRUCTIONS PET DRYER OWNER’S MANUAL MODEL: B-24 ,B-25 (115V/60Hz) XPOWER MANUFACTURE, INC. 220 Clary Avenue San Gabriel, CA 91776, USA Tel: 626-285-3301 Fax: 626-285-3302 www.xpower.
TABLE OF CONTENTS Introduction .......................................................................................................................................... 1 Operation .............................................................................................................................................. 2 Specifications ........................................................................................................................................ 2 Important Safety Instructions ..
INTRODUCTION XPOWER B-24/B-25 are ETL/C-ETL certified professional level pet dryers. The XPOWER B-24 Heated Force Dryer gives you the power of heat to dry those pets even faster! The variable speed control along with dual heat settings gives you complete control over the amount of air and temperature you need to dry any dog, small or large with short or long hair. XPOWER Professional Double Motor Pet Dryer B-25 provides more power to dry pets quickly while saving your time.
OPERATION 1. Place the dryer on a flat surface. Plug the electrical cord into a 3-prong GFCI outlet. 2. To use as a dryer, connect the hose to the front hose connector and attach the desired nozzle. Turn on switch to desired speed. 3. For B-24,to use heating element, choose desired heat setting (I or II) or leave on off setting. 4. To reduce the risk of injury, close supervision is necessary when the unit is used near children. Do not allow children to play with or around the unit.
SAFETY INSTRUCTIONS WARNING: IMPORTANT SAFETY PRECAUTIONS! When using electrical appliances, especially when children or animals are present, basic safety precautions should always be followed to reduce the risk of fire, electric shock, and personal injury, including, but not limited to the following: • Do not leave the dryer and animal unattended while the product is in use. • Unplug dryer when not in use. • Do not use extension cords with the product. • Do not unplug unit by pulling on cord.
SAVE THESE INSTRUCTIONS HOUSEHOLD and COMMERCIAL USE GROUNDING INSTRUCTIONS This appliance must be grounded. In the event of malfunction or breakdown, grounding provides a path of least resistance for electric current to reduce the risk of electric shock. This appliance is equipped with a cord having an equipment-grounding conductor and a grounding plug. The plug must be plugged into an appropriate outlet that is properly installed and grounded in accordance with all local codes and ordinances.
B-24 PARTS LIST 1 2 3 4 5 6 7 8 Left housing Right housing Switch Rubber feet Air outlet grid Heater element round cover Heater element Motor rubber sleeve 9 10 11 12 13 14 15 16 Motor Dustproof cover Motor filter Dust case Dust case filter Rear cover Rear cover connector Crossed cover 17 18 19 20 21 22 Rear cover baffle Inlet filter Hose Round groomer rake Flat nozzle Cone nozzle 1 3 4 19 5 6 8 9 8 10 12 11 7 2 20 21 22 -5- 4 13 14 17 18 15 16
B-25 PARTS LIST 1 2 3 4 5 6 7 8 Rear cover baffle Inlet filter Crossed cover Rear cover connector Rear cover Dust case filter Dust case Motor filter 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 Dustproof cover Power cord Cord bushing 1 Left housing Cord clip Cord bushing 2 Switch knob Switch plate PCB board assembly 1 Cord bushing 3 Motor rubber sleeve Motor Rubber feet Right housing PET film Cord connector 1 25 26 27 28 29 30 31 32 33 Cone nozzle Cord connector 2 Hose 34 Air outlet grid Hose sleeve Hose
MAINTENANCE IMPORTANT! Always turn off the unit and disconnect from electrical outlet before maintenabce or cleaning. Product Maintenance: 1. To keep the Pet Dryer, use a damp cloth to wipe the surface of the housing. Removable part(s) and filters may be cleaned with water and dried thoroughly before reassembling. 2. When not in use, unplug and store the Pet Dryer in a dry place indoors and keep out of reach of children.
XPOWER LIMITED WARRANTY XPOWER Manufacture, Inc. warrants this product to be free from defects in material and workmanship for a period of one (1) year from the date of original purchase. Wearable parts including but without limitation, filters, motor brushes, hoses and power cords are excluded from the warranty. The liability of XPOWER is limited solely to the cost of the repair or replacement of parts/the unit at XPOWER’s discretion.
Warranty Registration (for US user only) WARRANTY REGISTRATION Please complete mail or fax for your product warranty. For mail multiple units, please list serial numbers on aMANUFACTURE, separate sheet of paper.INC. For your productand warranty, please complete and / fax this form to XPOWER Address: Clary Avenue,Tel: San Gabriel, CA 91776, USA Address: 220 ClaryXPOWER Ave., MANUFACTURE, San Gabriel,INC., CA220 91776.
From: TO: XPOWER MANUFACTURE, INC.
