Use and Care Guide

Daisy Chain Specifications (applicable for model X-600A)
XPOWER Air Mover Model X-600A is daisy chainable with a low 3.8 amp draw.
The 12-amp on-board circuit breaker will allow two (2) additional X-600A units to
run on one circuit at the same time.
Filters (optional)
Note:
Air Mover has an on-board circuit breaker. If the auxiliary
outlet overloads, the circuit breaker will trip. If the breaker
trips, unplug the units and press the circuit breaker reset
button.
Plug the units back into the power source and turn on the
switch.
Accessories
A set of filters is available for the XPOWER Air Mover which will help prevent small debris and dust
from entering the Air Mover. To clean the filters: remove filters from the unit and wash with warm
soapy water, rinse with clean water and let dry thoroughly before reinstalling.
Installation:
Filters snap into the air inlets.
Note:
F ilter I is for the Motor side,
F ilter II is for the Fan side
Filter Removal:
Pull the filters out of the blower.
Note:
After cleaning make sure
the filters are dry before
installing.
- 9 -