XRA370504 X10 2018 Manual

14
DIFFERENTIAL
TRACK-WIDTH
303140-O
SHIM 3x5x2
303141-O
SHIM 3x5x1
303142-O
SHIM 3x5x0.5
SPUR GEARS
#375872 72T / 64P OPTION
#375875 75T / 64P OPTION
#375876 76T / 64P OPTION
#375878 78T / 64P OPTION
#375880 80T / 64P OPTION
#375896 96T / 64P INCLUDED
This nut affects the tightness and
stiffness of the rear differential.
Tighten the nut gently so the diff
does not slip under power, but do
not overtighten or the diff balls
and/or plates may be damaged.
IMPORTANT
2x
NOTE
ORIENTATION
NOTE
ORIENTATION
NOTE
ORIENTATION
Diff Grease
(HUDY #106211)
Bearing Oil
(HUDY #106230)
Diff Grease
(HUDY #106211)
OIL
Bearing Oil
(HUDY #106230)
OIL
Diff Grease
(HUDY #106211)
Diff Grease
(HUDY #106211)
8.0mm
7.8mm
3.0mm
3.2mm
Use additional shims to widen the rear
track-width. Use the same shims on
both sides. For initial assembly use
6.4x8.4x1mm shims.
The axle must have a VERY small amount
of side play. If there is no side play, the axle
may bind in the ball-bearings and damage
the bearings.
NOTE
ORIENTATION
The shim thickness affects the ride height of the car, so determine the proper
amount of shimming based on tire diameter.
IMPORTANT: Always use the same thickness of shims on both left & right sides.
Depending on the tires and their diameter, there are three ways to mount the alu
upper clamp:
1. Shims above clamp.
2. Shims between clamp and bulkhead.
3. Shims between clamp and bulkhead, clamp
turned upside-down.
4. BALL DIFFERENTIAL
930138
BA 3x8
941438
BB 1/4“x3/8“x1/8“
930130
B 3.1
963030
ST 3x8
960030
N M3
375090-O
6.4x8.4x1.0
908258
SCH M2.5x8
375392
ALU SCH M3x10
DETAIL
DETAIL