XRA370504 X10 2018 Manual

8
RIDE HEIGHT
RIDE HEIGHT
TRACK-WIDTH
The thickness of shims used affects
the ride height of the car, so
determine the proper amount of
shimming based on tire diameter.
Moves freely
2x
2x
RIDE HEIGHT ADJUSTMENT
INITIAL SETTING
above upper arm (0.5mm)
above steering block (1.3mm)
below steering block (0.2mm)
0.5mm
0.5mm
0.2mm
0.2mm
(4x)
OIL
use HUDY Silicone Oil
Use 0.6mm shim (#372294 - GOLD)
The number of washers used affects the ride height of the
car, so determine the proper amount of shimming based
on tire diameter.
LEFT RIGHT TRACK-WIDTH
+1mm
+0.5mm
0mm
-0.5mm
-1mm
193mm
192mm
191mm
190mm
189mm
+
=
INITIAL SETTING
INITIAL SETTING
The X10 has adjustable front track-width. There
are 3 different bushings - 0mm centric (included
in kit), or 0.5mm or 1.0mm eccentric (optional).
Use the same bushing in front and rear, and also
use the same orientation of the bushing on both
left & right sides.
Use the proper matching bushings to achieve the desired
front track-width.
INITIAL SETTING
The different holes
for suspension mounting allows for
wheelbase adjustment.
FRONT COIL SPRINGS - SOFT
#372176 C=1.5 GOLD OPTION
#372177 C=2.0 SILVER OPTION
#372178 C=2.5 BLACK OPTION
#372179 C=3.0 GREY OPTION
FRONT COIL SPRINGS
#372180 C=3.5 GOLD INCLUDED
#372181 C=4.0 SILVER OPTION
#372182 C=5.0 BLACK OPTION
#372183 C=5.5 GREY OPTION
M3 NUTS
#960030 STEEL SILVER INCLUDED
#960031 ALU SILVER OPTION
#296530-O ALU ORANGE OPTION
ALU ECCENTRIC BUSHINGS
#372316-O 0mm INCLUDED
#372317-O 0.5mm OPTION
#372318-O 1.0mm OPTION
#371014
X10’18 ALU FLEX 2.0MM CHASSIS - 7075 T6
Arm Reamer 3.0mm
3.0 mm
The front suspension parts were
updated to eliminate play to ensure
better steering performance. The
updated holes in the steering
blocks may cause a tighter fit of the
kingpin in the steering block; it is
important that the steering block
moves freely but without excessive
play. If the kingpin does not insert
into the steering block easily, use
a 3mm arm reamer to enlarge the
hole. Be very careful to remove only
enough material so you can insert
the kingpin without a lot of force.
LOW traction & bumpy track
10K cSt (#106510 HUDY)
HIGH traction & smooth track
30K cSt (#106530 HUDY)
1. FRONT SUSPENSION
372290
S 3.2x4.8x0.5
964032
S 3.2x4.8x0.2
965019
C 1.9
903312
SFH M3x12
960030
N M3
902310
SH M3x10