User's Manual

Document MV0319P.N
© Xsens Technologies B.V.
MVN User Manual
66
10.3.2.6 Floor level
Sets the height of the floor. Multiple floor levels can be set in one file. The current floor level is presented
in the dialog; see Figure 51 for an example.
Figure 51: Set floor level menu
Right mouse click on a contact bar to set the floor height to the height of that contact. The contact
detection will now be applied on the new floor height for all following samples.
Left mouse click and drag on the advanced bar allows you to set a floor height for a range of frames
10.3.2.7 Clipping
The clipping bar indicates when clipping has occurred in the data. This gives users an indication of when
movement has caused sensor data to be exceeded. Data should not be trusted at these times.
10.4 Reprocessing
MVN files contain all original data and can be used to re-process the file using other settings and
assumptions or with overruled external contacts, if needed. Anytime a change has been made to a file,
e.g. contact points, change of fusion engine, subject dimensions or use of MVN Awinda to contain
retransmitted data etc., the file must be reprocessed to ensure that the changes are implemented. It is
advisable to save the reprocessed file with a new filename, to be able to return to the original values.
To enable reprocessing press ‘Ctrl+Shift+P’ or click the icon:
The result of clicking the above icon can be changed from ‘Reprocess’ to ‘Auto-reprocess’ by clicking
on the dropdown arrow to right of the icon.
The upper bar will show the progress of the currently displayed frames when zoomed in. The lower bar
will show the progress of the total file. Once the upper bar has been completed, you can continue editing
frames in the current window. After the first pass, the progress bar will be green and the MVN Fusion
engine will apply the edited contact points.