Third Party Verification Claim
IAPMO RESEARCH AND TESTING, INC.
CERTIFICATE OF LISTING
Issued To: TAIZHOU JINGWEI SANITARY WARE CO., LTD Eective Date: August 2019
File Number: 8906 Revised Date: June 23, 2022
Product: Bathtubs (Plastic) Void After: August 2024
This certicate is not evidence of current listing.To verify listing status, visit the IAPMO R&T Product Listing Directory at pld.iapmo.org
Identification:
Manufacturer's name or trademark, or both, and the date of manufacture shall be permanently and legibly marked on the unit.
The product shall also bear the cUPC® certification mark. The manufacturer’s identity and cUPC® mark shall be readily visible
after installation.
Characteristics:
One piece plastic bathtubs are manufactured with or without walls and with right or left hand outlets. Bathtubs intended for
installation against a wall shall incorporate and integral, factory applied or field applied nailing flange in accordance with this
standard. Bathtubs without factory applied nailing flanges are listed as drop-in units only, and are not to be installed against the
wall. To be installed in accordance with the manufacturer’s instructions affixed to the unit and the requirements of the latest
edition of the Uniform Plumbing Code. Whirlpool piping is not included in this listing. Piping, if installed, must carry a separate
IAPMO listing.
TILE FLANGE KITS: The use of a listed tile flange kit allows installation against the wall.
Products listed on this certificate have been tested by an IAPMO R&T recognized laboratory. This recognition has been granted
based upon the laboratory's compliance to the applicable requirements of ISO/IEC 17025.
Page 2 of 18