Use and Care Manual

Draft
Test Report
No.: SHHL2006523861PL Date: JUL. 06, 2020 Page: 2 of 3
Test Conducted:
1. Resistance to temperature changes (According to EN 14516:2015+A1:2018 Clause 5.3.4)
Sample Size: 1 piece
Clause
Test
Method
/ Requirement
Result
Rating
5.3.4
Resistance to
temperature
changes
All baths shall show no evidence of distortion or other defects,
e.g. crazing, which will impair their cleanability.
Experience has shown that baths manufactured from the
stainless steel grades listed in Annex A, enamelled steel,
enamelled cast iron and glazed ceramics comply with this
requirement.
No evidence
of distortion
or other
defects
Pass
Since the data and / or information above division line of front page is provided by the applicant, the
relevant results or conclusions of this report are only made for these data and / or information, SGS
shall not be responsible for the authenticity and integrity of such data and information and the validity
of the results and / or conclusions arising therefrom. Testing results only apply to the sample as
received.
The declaration of conformity is based on non-binary acceptance decision rules with guard band, and
the guard band length parameter is 0. When the measured value falls in the guard band limit, the
declaration of conformity is “Conditional PASS” or “Conditional FAIL”.