Safety Notice

Note: This equipment has been tested and found to comply with the limits for a

Class B digital device, pursuant to part 15 of the FCC Rules. These limits are

designed to provide reasonable protection against harmful interference in a

residential installation. This equipment generates uses and can radiate radio

frequency energy and, if not installed and used in accordance with the instructions,

may cause harmful interference to radio communications. However, there is no

guarantee that interference will not occur in a particular installation. If this

equipment does cause harmful interference to radio or television reception, which

can be determined by turning the equipment off and on, the user is encouraged to

try to correct the interference by one or more of the following measures:

—Reorient or relocate the receiving antenna.

—Increase the separation between the equipment and receiver.

—Connect the equipment into an outlet on a circuit different from that to which

the receiver is connected.

—Consult the dealer or an experienced radio/TV technician for help.

Specific Absorption Rate (SAR) information SAR tests are conducted using

standard operating positions accepted by the FCC with the phone transmitting at

its highest certified power level in all tested frequency bands, although the SAR is

determined at the highest certified power level, the actual SAR level of the phone

while operating can be well below the maximum value, in general, the closer you

are to a wireless base station antenna, the lower the power output.

Before a new mobile phone is a available for sale to the public, it must be

tested and certified to the FCC that it does not exceed the exposure limit

established by the FCC, Tests for each phone are performed in positions and

locations (e.g. at the ear and worn on the body)as required by the FCC.

For body worn operation, this mobile phone has been tested and meets the

FCC RF exposure guidelines when used with an accessory designated for this

product or when used with an accessory that contains no metal and that positions

the handset a minimum of 5mm from the body.