Operation Manual

Xterra SB440r Bike
9
STEP 1: SEAT ASSEMBLY & REAR STABILIZER
• Install the rear stabilizer tube(18) and secure with two 3/8” Carriage bolts (96), 3/8”
curved washers (97) and 3/8” cap nuts (98).
• Sitting next to the unit with the seat post (11) in your lap, connect the two wires together
(109 & 110). Secure the seat post to the main frame – be careful to not pinch the wires –
with the six 5/16” x 3/4” bolts (95), 5/16” split washers (73) and 5/16” flat washers (70).
• Lay the seat cushion (52) on the floor, cushion side down, and then lay the seat carriage
assembly (4 &14) on top of the seat cushion. Align the holes and secure the seat cushion
with four M6 x 15mm screws (99). Make sure seat cushion is facing the right direction.
• Secure the seat carriage assembly (4 &14) to the seat post with four 5/16” x 1-1/4” bolts
(90). Make sure these bolts are very tight. Assemble the plastic end caps (42) to the seat
carriage with four M5 x 12mm screws (81).
Assembly Instructions for Xterra SB440r