Operation Manual

Xterra SB440r Bike
11
STEP 3: Console Mast & Seat Back
• Secure the seat back assembly (5) to the seat carriage with six 3/8” x 3/4” bolts (101) and
3/8” flat washers (71). Make sure these bolts are very tight.
• Run the two wires (107 & 109) through the bottom of the console mast and out the hole at
the top. Slide the console mast into the mating tube; pull slightly on the two wires while you
install the console mast so they do not get pinched. Secure the mast with six 5/16” x 3/4”
bolts, four 5/16” Washers (70) on the side bolts and two 5/16” curved washers (102) on the
two front bolts. Make sure to start all six bolts first before tightening all the way.