Operation Manual

TR600 Treadmill

Console Mast Support

1. Install Console Mast Support (9) between Left and Right Uprights (4)

and (5). Use the combination M5 Allen Wrench and Phillips Head Screw

Driver (102) to tighten four Button Head Socket Bolts (125).

125

Final Process

1. The nal step will be to plug the power cord into the treadmill and the

other end into the wall outlet. Flip the power switch, located near the

power cord on the treadmill, to the ON position. Make sure the Safety

Tether Cord is properly attached and in place and press START.

2. The belt tension should be set correctly out of the box. If you notice the

belt slipping while you step on it or sliding to the side, it will need to be

adjusted. Follow the procedures listed in the Treadbelt Tracking

Adjustment Section near the end of this manual to make the proper

adjustments.

103

Hardware Step 4

#125. 5/16” x 3/4”

Button Head Socket

Bolt (4 pcs)