Instruction Manual

power off (MetaFly LED turns Off), although MetaFly’s

switch is still ON. No problem, when you’ll put the

MetaFly back on charge, it will be reactivated.

D- First flight - Triming the wings

From the very first flight, it is essential to check the

wings balance, and to adjust it if needed. If while flying,

you notice the following unbalanced flight:

*Immediately when launched, the MetaFly turns to one

side and go directly to the ground (big unsteadiness).

*The direction stick is in the middle position but the

MetaFly turn left or right in small circles.

*It seems that the MetaFly turns more easily to one side

than to the other.

Then you will have to trim the

wings.

Each wing is equipped with a ballast. Its base position is

nearest to the body. It can slide toward the end to create

a ballast differential between the 2 wings.

You must increase the ballast of the opposite wings to

the turning side you observed. For instance, If MetaFly

tends to turn to its right side, move ballast of its left wing

toward the end and leave the one on the right wing