Instruction Manual

15
unchanged (base position).
Try flying the MetaFly again, and if necessary, repeat the
process until you get a straight flight or an acceptable
slight turn. Your MetaFly is now balanced and its
performance is optimized.
NB: Flying with tail set in a high (5) or low (1) position
may require a different wing adjustment.
In order to fly the MetaFly with tail in high position in a
confined space and keep a precise control, it is
recommended to do a very precise wing adjustment with
the tail in that position.
VI – MANUAL BINDING
Each MetaFly is bind to its transmitter at factory and is
coded to be controlled only by its own transmitter. This
allows several persons to fly at same time in the same
place.
If for any reason, your MetaFly doesn’t bind to its
transmitter, you can manually reset the code in order to
bind it again following that steps:
switch off both MetaFly and the transmitter
Turn the direction stick to the right (max) and keep it
while switching ON the transmitter on (LED blink fast)/
Switch MetaFly ON. LED constant. The manual binding
is done.
WARNING: the manual binding process must be done
without any other transmitter around switched on.
VII – PARTS REPLACEMENT
Please refer to the “assembling your MetaFly” section.
Please contact our customer's service to get
replacement parts or instructions on «how to do it» at
[e-mail] or on our web site: